ingenuity 13099-NA Soothing Swing Dakota Instruction Manual

13099-NA
InLighten™ Soothing Swing – Dakota™
Swingingenuitybaby.com

13099-NA Soothing Swing Dakota

IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
WARNING
FALL and STRANGULATION HAZARDS: Infants have suffered head injuries falling from seats and have strangled in straps.

• ALWAYS use the restraint system. Adjust to fit snugly.
• STOP using product when infant attempts to climb out (approximately 9 months).
• DO NOT use this product once your child can sit up unaided or weighs more than 9 kg/20 lbs. DO NOT use this product if your child weighs less than 3kg/6 lbs.
• Stay near and watch baby during use. This product is not safe for sleep or unsupervised use. If baby falls asleep, remove baby as soon as possible and place baby on a firm, flat sleep surface such as a crib or bassinet.
• Never let the child sleep in this product.
• DO NOT move or lift this product with the baby inside it. Never lift product using a toy bar as a handle.
• ALWAYS place product on floor. NEVER use this product on an elevated surface (e.g. a table).
• NEVER attach any additional strings or straps to product or toy bar.

SUFFOCATION HAZARD: Young infants have limited head and neck control. If the seat is too upright, infant’s head can drop forward and compress the airway.

• ALWAYS keep swing seat fully reclined until infant is at least 4 months old AND can hold up head without help.

SUFFOCATION HAZARD: Babies have suffocated when seats tipped over on soft surfaces.

• NEVER use on a bed, sofa, cushion, or other soft surface.

Prevent Serious Injury or Death

• NEVER leave the child unattended.
• To avoid injury ensure that children are kept away when unfolding and folding this product.
• Do not let children play with this product.
• When using the USB cord, only use the one supplied with this swing.
• Check the USB cord and wall adaptor regularly for damage. Do not use if any damage has occurred.
• Use USB cord only with a 5 Volt/1 Amp (5 Watts) USB A wall adaptor.
• The product shall only be used with a transformer for toys.
• The transformer is not a toy.
• This product is only to be connected to equipment bearing either of the following symbols:
• Do not use extension cords.
• NEVER use as an infant carrier for automobile or airline travel.

CAUTION

• This product contains small parts. Adult assembly required.

IMPORTANT

• The provided USB cord is 183cm in length.
• Please read all instructions before assembly and use of the product.
• Care should be taken in unpacking and assembly.
• Examine product frequently for damaged, missing, or loose parts.
• DO NOT use if any parts are missing, damaged, or broken.
• Contact Kids2 for replacement parts and instructions if needed. Never substitute parts.
• This product does not replace a cot or a crib. Should the child fall asleep, then it should be placed in a suitable cot or crib.

Battery Information

The remote control requires a CR2032 (3V) battery (included).
The vibration Unit requires (1) size C/LR14 (1.5V) alkaline batteries (not included).
WARNING:

• INGESTION HAZARD: This product contains a button cell or coin battery.
• DEATH or serious injury can occur if ingested.
• A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours.
• KEEP new and used batteried OUT OF REACH of CHILDERN.
• Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.
• Call a local poison control center for treatment information.

CAUTION: Follow the battery guidelines in this section. Otherwise, battery life may be shortened or the batteries may leak or rupture. To prevent battery leaks, which can burn skin and eyes:

• Examine product and make sure the battery compartment is correctly secured, e.g. that the screw or other mechanical fastener is tightened. Do not use if compartment is not secure.
• Dispose of used button batteries immediately and safely. Batteries can still be dangerous.
• Always keep batteries away from children.
• Never mix old and new batteries, or batteries of different brands or types.
• Always replace the entire set of batteries at one time.
• Do not mix alkaline, standard, or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Install the batteries so that the polarity of each one matches the markings in the battery compartment.
• Do not short-circuit the batteries.
• Do not store batteries in areas that have extreme temperatures (such as attics, garages, or automobiles).
• Do not force discharge, recharge, disassemble, heat above 60C or incinerate. Doing so may result in injury due to venting, leakage or explosion resulting in chemical burns.
• Remove exhausted batteries from the battery compartment.
• Never attempt to recharge a battery unless it is specifically marked “rechargeable.”
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Dispose of used batteries immediately.
• Please use the correct disposal method for batteries.
• Remove batteries before putting the product into storage for a prolonged period of time.
• Weak batteries cause erratic product operation, including distorted sound, dimming or failed lights, and slow or non-working motorized parts. Because each electrical component requires a different operating voltage, replace the batteries when any function fails to operate.
• Do not dispose of product or batteries in fire, batteries may explode or leak.
  This symbol indicates that the product is not to be disposed of in household waste as batteries contain substances that can be damaging to the environment and health. Contact local authority for recycling & collection information.

Care and Cleaning

• Seat pad – Remove from frame. Fasten buckles on seat restraint and seat pad. Fasten all hook-andloop patches to the corresponding patch. Machine wash with cold water, gentle cycle. No bleach. Tumble dry, using low heat.
• Bolster – Machine wash with cold water, gentle cycle. No bleach. Air dry flat.
• Toys – Wipe clean with a damp cloth and mild soap. Air dry. Do not immerse in water.
• Frame – Wipe the metal frame with a soft, clean cloth and mild soap.
• Storage – When putting swing away for storage, always store in a dry location, away from any heat sources, and out of the sun.

Description
A| (2)| M5 Philips Head Screws
B| (2)| M5 Nuts
1| (1)| Swing head assembly with control
2| (1)| Left leg tube
3| (1)| Left front foot
4| (1)| Right leg tube
5| (1)| Right front foot
6| (1)| Swing arm assembly
7| (1)| Cross brace assembly
8| (1)| Right recline
9| (1)| Left recline
10| (1)| Footrest tube
11| (1)| Back rest tube
12| (1)| Vibe Unit
13| (1)| Mobile with toys
14| (1)| USB cable
15| (1)| Seat Pad
16| (1)| Head rest
17| (1)| Bolster
18| (1)| toys(Circle)
19| (1)| toys(elephant)
20| (1)| IR Remote

|
---|---
|
|
|
|

Using the Seat Restraint

|
---|---

Using the Recline Function

Rotation of the seat

Storage and Travel

IR Remote

Using the Swing Control Module

| Touch the Power switch to power the Swing Control Module.
---|---
| The Speed Selector function provides 5 speed settings and OFF. The LEDs operate sequentially and in bar graph mode. To start the swing function, touch the button until the flashing LED bar graph displays the desired setting.
When you change the speed setting during swing motion, the LED bar graph will flash for five seconds during the speed adjustment. When the swing timer expires, the swing stops and the Speed Selector and Timer LEDs turn OFF.
| Use the Swing Timer Select function to turn OFF the swing automatically. Touch the button to sequence to the desired timer setting of 30, 60, or 90 minutes. The three LEDs above the button indicate the selected time period. If you do not select a timer setting (all LEDs are OFF), the unit uses a default time of 30 minutes for auto-shutoff. To use the swing function after auto- shutoff, either press the Swing Timer Select button or the Speed Selector button.
| Touch the Nature Sounds/Music button to begin music and nature sounds playback. Touch as needed to select the desired nature sound or song. Auto- shutoff occurs after about 20 minutes.
| Touch the Volume Control switch as needed to turn off or adjust the volume for music and nature sounds.
| Press the Mobile Illumination button to start the mobile and to switch on the lights. Press it again to get into a random light/play pattern.

Using the Vibration Unit

To use the vibration function: Push the button to turn on or turn off the vibe unit.

FCC Statement / CAN ICES-3 (B) / NMB-3(B)

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.  This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Find us on Facebook and Instagram @ingenuitybaby
Toys • Activity Gyms • Bouncers • Rockers • Swings • Bassinets • Playards • High chairs • Booster Seats
ingenuitybaby.com

MANUFACTURED FOR • FABRIQUÉ POUR ©2023 KIDS2, INC. www.kids2.com/help
KIDS2, INC. ATLANTA, GA USA 30305 • 1-800-230-8190
IMPORTED BY • IMPORTÉ PAR
KIDS2 AUSTRALIA PTY LIMITED CASTLE HILL, NSW AUSTRALIA 2154 • (02) 9894 -1855
KIDS2 SHANGHAI LIMITED Room7401, Shanghai Tower, No.479 Lujiazui Ring Road , Pudong New Area, Shanghai 200120 •+86 21 31025990
KIDS2 JAPAN K.K. c/o ARK Outsourcing KK 4-3-5-704, Ebisu, Shibuya-ku, Tokyo, Japan 150-0013 • (03) 5322-6081
KIDS2 UK LTD. 725 CAPABILITY GREEN, LUTON, BEDFORDSHIRE, UK, LU1 3LU • +44 01582 816 080
KIDS2 EUROPE BV 5 KEIZERS, KEIZERSGRACHT 287, 1016 ED AMSTERDAM, NETHERLANDS • +31 20 2410934
KIDS2 US MÉXICO S.A. DE C.V. • (55) 5292-8488
MADE IN CHINA

13099_3NA_USB_IS110723

References

• Ingenuity™ – Kids2, LLC
• Kids2 Contact Us – Kids2, LLC

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>