COSHARE HD20B High Speed Hair Dryer User Manual

COSHARE HD20B High Speed Hair Dryer

Please read this manual carefully before using the product and keep it as a reference for future use

Product Instruction

1. Air outlet
2. Sliding swit ch
3. Heat setting button
4. Wind speed button
5. Heat setting indicator
6. Wind speed indicator
7. Detachable filter cover

Note: Illustrations of the product, accessories, and user interface in the user manual are for reference purposes only. Actual products and functions may vary due to product enhancements.

Function

Heat setting button

• Tap the heat setting button to switch the airflow among 3 heat modes in the following sequence: cool, warm, hot, cool…
• Press the heat setting button for 2 seconds to enter the auto cool/hot alternating mode. At this mode, tap the heat setting button to return to the cool mode.

Wind speed button

• Tap the wind speed button to switch the airflow among 3 speed modes in the following sequence: low, medium, high, medium, low…

Function

Note:

1. The hot mode is suitable when hair is wet after washing. To avoid hair damage caused by the high temperature when the hair is not wet enough, it is recommended to switch to other 3 modes (cool, warm or cool/hot alternating modes) when the hair is going to dry.
2. At the hot mode, the heat temperature at the outlet will be over 100 °C, please keep distance from the outlet when it works.
3. In general, the critical temperature for hair cuticles to start getting damage is 60°C. The warm mode keeps at 57°C to best take care of your hair.

Product Specifications

• Model: HD20B
• Rated Voltage: 230V~
• Rated Frequency : 50Hz
• Rated Power : 1300W
• Product Dimensions: 2498569mm

Cleaning and Maintenance

1. Rotate in the direction shown in Figure ① to remove the detachable filter cover.
2. After removal, switch to low speed mode, then press the wind speed button for 5 seconds to activate the self-cleaning function: the hair dryer slows down, then blows out fine rubbish and dust after the motor reverses rotation for 10 seconds.
3. After cleaning, turn off the hair dryer by moving down the sliding switch, then rotate in the direction shown in Figure ② to replace the filter cover in its original position.
4. After turning off and on again, the hair dryer will blow again.

Important

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children without supervision.

• When the hairdryer is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the hairdryer is switched off.
• For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
• WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
• Keep away from water! Do not use this product near or over water contained in baths washbasins, sinks, etc. If, for some reason, the product has fallen into water: first unplug it immediately. Then, dispose of the product. It must not be used again.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons to avoid a hazard.
• Even when the hair dryer is switched off, the power is still on. Always pull out the mains plug when not in use.
• Never obstruct the air grills.
• This product is equipped with an automatic overheating protection device. If the appliance overheats, it will switch off. Unplug the appliance. After cooling down for a few minutes, the appliance can be used again. Before reusing, check the inlet and outlet grilles for possible blockage by fluff, hair, etc. If in doubt, consult your dealer or a COSHARE Service Centre.
• If the mains cord of this appliance is damaged, it must only be replaced by COSHARE or their service representative, as special tools and/or parts are required.
• For examination or repairs always return the appliance to an authorized COSHARE service centre. Unqualified repair work can lead to extreme hazards for the user

WEEE Disposal and Recycling Information
All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities for more information about the location as well as the terms and conditions of such collection points. Environment-friendly disposal You can help protect the environment!Please remember to respect the local regulations: hand in the non-working electrical equipment to an appropriate waste disposal center. The packaging material is recyclable. Dispose of the packaging in an environmentally friendly manner and make it available for the recyclable material collection service.

Hereby, Shenzhen Cuco Smart Technology Co., Ltd. declares that the Coshare hair dryer complies with Directive 2014/35/EU. The full text of the EU Declaration of Conformity is available at the following internet address: https://cedeclaration.gosund.com/

• WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
• WARNING: Do not use this device in a bathtub, shower, or water-filled reservoir.

FAQ

Q: The hair dryer doesn’t work, or the red/white indicator flashes quickly.

1. The hair dryer may be overheated, please keep it rest for about 10 minutes before using it again.
2. The voltage may be unstable, it is recommended to replace another wall socket to try again.
3. The filter is blocked, it is recommended to clean the filter

Declaration

Hereby, Shenzhen Cuco Smart Technology Co., Ltd declares that the hair dryer complies with Directive 2014/35/EU. The full text of the EU Declaration of Conformity is available a the following internet address: https://cedeclaration.gosund.com

Warranty Card

• Warranty Card
• Buyer Name:
• Email Address:
• Phone Number:
• Product Name & Model Number:
• Product Serial Number:
• Purchase invoice number:
• Purchase Date:
• Problem Description:

Customer Service

Customer Service email: services@coshareglobal.com Official website: www.coshareglobal.com Manufacturer: Shenzhen Cuco Smart Technology Co., Ltd. Address: Room 201, 301, Building A, No.12 Difu Road, Guxing Community, Xixiang Street, Baoan District, Shenzhen,518000, Guangdong, P. R. China

References

• cedeclaration.gosund.com
• cedeclaration.gosund.com/

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>