SWS AP-BTM-1200-1 Audiopipe Marine Bluetooth Audio Receiver Instructions
- May 15, 2024
- SWS
Table of Contents
SWS AP-BTM-1200-1 Audiopipe Marine Bluetooth Audio Receiver
Specifications
- Model: AP-BTM-fi!OO
- Wireless Music Transmission Receiver
- Power: +12V
- Color coding : Red for Power, Black for Ground
CONNECTION
Product Usage Instructions
Connection Setup
To use the wireless music transmission receiver, follow these steps:
- Connect the red wire to the power source (+12V) and the black wire to the ground.
- Connect the RCA output of the receiver to the amplifier.
Pairing Your Device
To pair your device for operation:
- Ensure that your device’s Bluetooth is enabled.
- Search for available Bluetooth devices on your device.
- Select ‘AP-BTM-fi! OO’ from the list of available devices to pair.
Wiring options
- Red —- (+12V) Power
- Black —- (- 12V) Ground
- Blue/White Strip —- Remote Turn on (Output to Amp)
- RCA —- (3.5mm) Audio output (Amp)
Unit installation
- Connect Red (+12V) wire to constant power (battery)
- Connect Black (-12V) wire to chassis ground
- Connect the Blue/White Strip wire (remote out) to the amplifier
- Connect RCA output to the amplifier
Pairing your device (required for operation)
- Ensure your streaming device has wireless music stream enabled and that the power is turned on the AP-BTM-1200. (The blue LED on the AP-BTM-1200 will blink to indicate it is in pairing mode.)
- Within your streaming device’s wireless music stream setup menu, select “AP-BTM-1200” from the list of pairable devices.
- When successfully connected, the blue LED on the AP-BTM-1200 will stop blinking and remain lit.
A single beep will be heard through the connected audio system.
FCC statement
FCC compliance statement
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, under Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used by the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This device and its antennas must not be co-located or operated in conjunction with any other antenna or transmitter.
Radiation Exposure Statement
To maintain compliance with FOC’s RF Exposure guidelines, This equipment
should be installed and operated with a minimum distance of 2cm from your
body.
FAQ
Frequently Asked Questions
- Q: What should I do if the device is not pairing?
- A: If the device is not pairing, try the following steps:
- Make sure the wireless music transmission receiver is powered on.
- Ensure that the receiver is within range of your device.
- Restart both the receiver and your device before attempting to pair again.
- Q: Can I connect multiple devices to the receiver simultaneously?
- A: No, the receiver can typically only be connected to one device at a time. To switch devices, disconnect the current one and pair a new device following the pairing instructions.