ingenuity 13097-NA Soothing Swing Nally Instruction Manual

ingenuity 13097-NA Soothing Swing Nally

IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE

WARNING

FALL and STRANGULATION HAZARDS : Infants have suffered head injuries falling from seats and have been strangled in straps.

• ALWAYS use the restraint system. Adjust to fit snugly.

• STOP using product when the infant attempts to climb out (approximately 9 months).

• DO NOT use this product once your child can sit up unaided or weighs more than 9 kg/20 lbs. DO NOT use this product if your child weighs less than 3kg/6 lbs.

• Stay near and watch the baby during use. This product is not safe for sleep or unsupervised use. If the baby falls asleep, remove the baby as soon as possible and place the baby on a firm, flat sleep surface such as a crib or bassinet.

• Never let the child sleep in this product.

• DO NOT move or lift this product with the baby inside it. Never lift a product using a toy bar as a handle.

• ALWAYS place the product on the floor. NEVER use this product on an elevated surface (e.g. a table).

• NEVER attach any additional strings or straps to the product or toy bar.
  SUFFOCATION HAZARD : Young infants have limited head and neck control. If the seat is too upright, the infant’s head can drop forward and compress the airway.

• ALWAYS keep the swing seat fully reclined until the infant is at least 4 months old AND can hold up the head without help. SUFFOCATION HAZARD: Babies have suffocated when seats are tipped over on soft surfaces.

• NEVER use on a bed, sofa, cushion, or other soft surface.

Prevent Serious Injury or Death

• NEVER leave the child unattended.
• To avoid injury ensure that children are kept away when unfolding and folding this product.
• Do not let children play with this product.
• When using the USB cord, only use the one supplied with this swing.
• Check the USB cord and wall adaptor regularly for damage. Do not use if any damage has occurred.
• Use USB cord only with a 5 Volt/1 Amp (5 Watts) USB A wall adaptor.
• The product shall only be used with a transformer for toys.
• The transformer is not a toy.
• This product is only to be connected to equipment bearing either of the following symbols:
• Do not use extension cords.
• NEVER use as an infant carrier for automobile or airline travel.

CAUTION

• This product contains small parts. Adult assembly is required.

IMPORTANT

• The provided USB cord is 183cm in length.
• Please read all instructions before assembly and use of the product.
• Care should be taken in unpacking and assembly.
• Examine product frequently for damaged, missing, or loose parts.
• DO NOT use if any parts are missing, damaged, or broken.
• Contact Kids2 for replacement parts and instructions if needed. Never substitute parts.
• This product does not replace a cot or a crib. Should the child fall asleep, then it should be placed in a suitable cot or crib.

Care and Cleaning

• Seat pad – Remove from frame. Fasten the buckles on seat restraint and seat pad. Fasten all hook-and-loop patches to the corresponding patch. Machine wash with cold water, gentle cycle. No bleach. Tumble dry, using low heat.
• Bolster – Machine wash with cold water, gentle cycle. No bleach. Air dry flat.
• Toys – Wipe clean with a damp cloth and mild soap. Air dry. Do not immerse in water.
• Frame – Wipe the metal frame with a soft, clean cloth and mild soap.
• Storage – When putting swing away for storage, always store in a dry location, away from any heat sources, and out of the sun.

not included

Use USB cord only with a 5 Volt/1 Amp (5 Watts) USB A wall adaptor. Usar cable USB solamente con un adaptador de pared USB-A de

INSTALLATION INSTRUCTION

Using the Seat Restraint

Using the Recline Function

Rotation of the seat

Storage and Travel

Using the Swing Control Module

• Touch the Power switch to power the Swing Control Module.

• The Speed Selector function provides 5-speed settings and OFF. The LEDs operate sequentially and in bar graph mode. To start graph displays the desired setting.
  When you change the speed setting during swing motion, adjust. When the swing timer expires, the swing stops and the Speed Selector and Timer LEDs turn OFF.

• Use the Swing Timer Select function to turn OFF the swing automatically.

• Touch the button to sequence to the desired timer setting of 30, 60, or 90 minutes. The three LEDs above the button indicate the selected period. If you do not select a timer setting (all LEDs are OFF), the unit uses a default time of 30 minutes for auto-shutoff. To use the swing function after auto-shutoff, either press the Swing Timer Select button or the Speed Selector button.

• Touch the Nature Sounds/Music button to begin music and nature sounds playback. Touch as needed to select the desired minutes. the volume for music and nature sounds.

• Press the Mobile Illumination button to start the mobile and to switch on the lights. Press it again to get into a random light/play pattern.

FCC Statement / CAN ICES-3 (B) / NMB-3(B)

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used following the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Find us on Facebook and Instagram @ingenuitybaby Retrouvez-nous sur Facebook et Instagram @ingenuitybaby

• Toys
• Activity Gyms
• Bouncers
• Rockers
• Swings
• Bassinets
• Playards
• High chairs
• Booster Seats
• ingenuitybaby.com

MANUFACTURED FOR • FABRIQUÉ POUR ® ©2023 KIDS2, INC. www.kids2.com/help KIDS2, INC. ATLANTA, GA USA 30305 • 1-800-230-8190 IMPORTED BY • IMPORTÉ PAR KIDS2 AUSTRALIA PTY LIMITED CASTLE HILL, NSW AUSTRALIA 2154 • (02) 9894-1855 KIDS2 SHANGHAI LIMITED Room7401, Shanghai Tower, No.479 Lujiazui Ring Road , Pudong New Area, Shanghai 200120 •+86 21 31025990 KIDS2 JAPAN K.K. c/o ARK Outsourcing KK 4-3-5-704, Ebisu, Shibuya-ku, Tokyo, Japan 150-0013 • (03) 5322-6081 KIDS2 UK LTD. 725 CAPABILITY GREEN, LUTON, BEDFORDSHIRE, UK, LU1 3LU • +44 01582 816 080 KIDS2 EUROPE BV 5 KEIZERS, KEIZERSGRACHT 287, 1016 ED AMSTERDAM, NETHERLANDS • +31 20 2410934 KIDS2 US MÉXICO S.A. DE C.V. • (55) 5292-8488 MADE IN CHINA • HECHO EN CHINA • FABRIQUÉ EN CHINE

References

• Ingenuity™ – Kids2, LLC
• Kids2 Contact Us – Kids2, LLC

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>