EVOLUTION 903FS0000 Sea Doo Spark Ribbon Delete Installation Guide
- May 15, 2024
- Evolution
Table of Contents
2014+ Sea Doo Spark Ribbon Delete
SKU(s): 903FS0000
INCLUDED PARTS
- (1) Ribbon Delete
- (1) 60-80mm Worm Drive
- (2) Zip Ties
REQUIRED TOOLS
Cutters
Screwdriver
Step 1: Remove the upper hull. See Sea Doo Spark Hull Removal Instructions.
Step 2: Locate the throttle body, cut (2) zip ties holding the fuel line to
the plenum. Step 3: Remove the pinch clamp from the throttle body boot to
plenum. Discard. Step 4: Pull the throttle body boot off the plenum. Located
in the plenum is the flame arrestor. Step 5: Remove the
flame arrestor and seal. Step 6: Install the ribbon delete into the plenum
until it bottoms out. Reinstall the throttle body boot and supplied clamp.
Step 7: Install (2) zip ties holding the
fuel hose to the plenum.
Thank you for choosing Evolution Powersports products. If you require further
assistance, please call our Tech Support @ (715) 247-3862
Note: This product is exempt from the emission standards and related
requirements of 40 C.F.R. § 1051 as provided by 40 C.F.R. § 1051.620, and
California law [e.g., vehicle code§§ 27156 and 38391]. This product is sold
only for use in connection with EPA certified, purpose-built, nonroad vehicles
used solely for closed course, nonroad competition/racing and not used for any
recreational purpose or on public highways or right of ways maintained by and
open to the public. This product is sold only in connection with machines that
do not fall under state and/or federal noise or emission
standards/regulations. Purchasers who/that purchase this product represent and
warrant that the product is purchased only in connection with EPA -certified,
emission-regulations-exempt and noiseregulations-exempt competition/racing
vehicles as interpreted under applicable state and/or federal law. Questions:
Call Evolution Powersports at
(715) 247-3862.
WE’D LOVE TO HEAR FROM YOU
LEAVE A REVIEW & STAY CONNECTED!