lyyt 24V High Output LED Tape User Manual

May 15, 2024
lyyt

lyyt 24V High Output LED Tape

Product Information

Specifications

  • Colour temperature: 3000K Warm White or 6000K Cool White
  • Voltage: 24Vdc
  • Reel Length: 5m
  • IP Rating: IP20 (for indoor use only)
  • LED quantity per meter: 120
  • Cut points: Every 5cm

FAQ

  • Q: Can I use this LED tape outdoors?
    • A: No, the IP20 rating indicates that this tape is suitable for indoor use only.
  • Q: How do I calculate the power supply needed for a specific length of tape?
    • A: Refer to the table provided in the manual for current requirements based on tape length. Ensure the power supply has higher capacity in Amps than the total current required for the installed tape length.
  • Q: Can I connect multiple reels of tape together?
    • A: Yes, up to 25m of tape can be linked together by connecting additional reels. Use parallel wiring to avoid dimming at the far end due to voltage drop.

Introduction And Specification

Introduction

Lyyt IP20 High Output LED Tape is supplied on 5m reels and operates from a 24Vdc power supply. The tape consists of 120 LED’s per metre and is available in either 3000K Warm White or 6000K Cool White varieties. The tape can be cut to the desired length on the designated cutting points every 5cm. The 24V High Output LED Tape has a wide variety of applications such as in hospitality, retail, offices, displays, exhibitions and more. IP20 versions are for indoor use only.

Specification

Colour temperature 156.786UK: 3000K, 156.788UK: 6000K
Voltage 24Vdc
Beam angle 120°
LED Type 2835 Sanan
Reel Length 5m
IP Rating IP20
Power consumption p/m 12.8W
Current p/m 533mA
LED quantity p/m 120
LED spacing 8.3mm
Cut points 5cm
Cross-section 10 x 1.2mm
Weight 230g

This product is intended to be professionally installed, observing relevant electrical safety procedures.
Lyyt LED Tape has a self-adhesive backing to allow it to be easily attached to a clean, non-porous surface.

Where less than 5m of tape is needed, there are solder points as shown below, where the tape may be cut to size. These cut points are at 5cm intervals. To re-connect to another length of tape after cutting, solder a wire from “+” to “+” and a wire from “-” to “-” as shown below. Some accessories are supplied with the tape reel for this purpose. For best protection of this tape, we recommend inserting the tape into one of our Aluminium Profiles.

Each 5m reel of tape is fitted with a 2.1mm DC jack for power input for easy connection to a power supply. This connector may be removed and stripped for bare wire connection if a 2.1mm jack is not fitted to the power supply. If the power supply has enough capacity to power more than one reel, another reel can be connected to the end of the first reel.

For 24V tape, up to 25m can be linked in this manner. Using a separate wire to loop “+” and “-” back to the power supply will help to avoid dimming at the far end through voltage drop. To connect beyond these lengths, a parallel wire must be run from the power supply to the further reels of tape.

It is imperative that the power supply should have higher than the rated capacity in Amps (A) for the current required to power the length(s) of LED Tape installed. Likewise, if controllers and amplifiers/repeaters are used, these must have adequate capacity for the tape being controlled.

Please see the table below for reference

Tape Length 5m 10m 15m 20m 25m
Current for 24V tape 120 LED/m 2.5A 5A 7.5A 10A 12.5A

Please visit www.avsl.com to select from our range of 24Vdc power supplies that are suitable for powering Lyyt LED Tapes.

This product is classed as Electrical or Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life. The goods must be disposed of according to your local council guidelines.

Errors and omissions excepted.

Copyright© 2023 AVSL Group Ltd,

Contact

  • Unit 2 Bridgewater Park, Taylor Road, Trafford Park, Manchester. M41 7JQ.
  • www.avsl.com
  • AVSL (Europe) Ltd, Unit 3D North Point House, North Point Bus. Park, New Mallow Road, Cork, Ireland.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals