JUNG UMA-MA2-KS2 Montage Adapter 2fach Instruction Manual
- May 15, 2024
- JUNG
Table of Contents
JUNG UMA-MA2-KS2 Montage Adapter 2fach
Product Information
Specifications
- Product Name: Montageadapter 2fach UMA-MA2-KS2
- Maximum Capacity: 2 Universal Modular Jack Sockets Cat6A (A, B)
- Mounting Options: Inclined or Horizontal
- Installation Depth: 60mm
- Installation Standard: DIN 18015-1
FAQ
- Q: Can I use accessories other than DIN 49073 compatible sockets?
- A: It is recommended to use only accessories compliant with DIN 49073 standards for safe installation.
- Q: What should I do if the latching mechanism does not engage properly during installation?
- A: Ensure the module is correctly positioned with the latching groove at the top before swinging it down to engage the latching lug at the bottom.
General
- The supporting frame (hereinafter referred to as the adapter) is used to accommodate a maximum of two universal modular jack sockets Cat6A (A, B).
- The modules can be mounted at an angle (as delivered, see Fig. 7a) or horizontally (see Fig. 7b) thanks to the flexible design of the mounting plate (D), the swivelling module holder (E) including positioning aid in addition to the plastic middle section (C). Installation is completed with a TAE center plate.
Installation And Mounting
Installation site
- Only use accessory sockets in accordance with DIN 49073 with a depth of ≥ 60 mm for installation as per DIN 18015-1.
- (We recommend installation in device boxes with an extended connection space, e. g. electronics box.)
- Do not use the adapter for any other purpose.
Mounting
Inclined mounting (Fig. 7a, rear view)
Before inclined mounting, please check the suitability of the used Keystone module for this mounting position!
- Insert the ready-to-install module (B) into the module holder from behind (Fig. 3) depending on the cable feed (left or right).
- Position the module with the latching groove at the top in the upper edge (G) of the module holder and swing it down until the latching lug engages at the bottom (Fig. 4).
Horizontal mounting (Fig. 7b, rear view)
- Use a screwdriver (I) to disengage the module holder at both left-hand and right-hand locking points (H) and remove it from the adapter.
- Pull the plastic middle section (C) upwards and remove it from the adapter. Please retain the plastic cover in case you wish to mount it at an angle at a later date.
- Insert the module holder again from behind (Fig. 5). Use the positioning aid (J) and snap the module holder flat into the rear wall of the adapter.
- Now insert the modules as desired and as described above.
Demontage
- Remove the complete module holder (Fig. 6) including modules from the adapter.
- Release the appropriate module from the module holder by pressing on the black locking tab (see white arrow).
Accessories
The following accessories are available:
- centre plates ref.-no. .. 569 T .., .. 969 T .. of all design ranges
Subjected to technical changes
CONTACT
ALBRECHT JUNG GMBH & CO. KG
- Volmestraße 1 58579 Schalksmühle GERMANY
- Tel. +49 2355 806-0
- Fax +49 2355 806-204
- kundencenter@jung.de
- www.jung.de
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>