AiPOWER GXS4300iDC Inverter Generator User Guide
- May 15, 2024
- Aipower
Table of Contents
AiPOWER GXS4300iDC Inverter Generator
Product Information
Specifications:
- Model: GXS4300iDC
- Engine Oil: 10W-30
- Fuel Type: Unleaded Gasoline (87 Octane)
- Propane/LPG Compatibility
Product Usage Instructions
1. Adding Lubricant and Fuel:
Remove the maintenance cover and use a funnel to pour 10W-30 engine oil into the engine, filling it to the upper mark of the oil dipstick. Use clean, fresh regular unleaded gasoline with a minimum of 87 octane.
2.Starting the Generator:
- Turn the starting dial switch to the START position.
- For restarting a warm engine, turn the starting dial switch directly to the RUN position.
- Pull the recoil starter slowly until resistance is felt, then pull rapidly.
- Connect the LPG gas hose to the propane fuel source.
- Fully open the Propane/LPG cylinder knob.
- Turn the starting dial switch to the RUN position.
- Turn the starting dial switch to the OFF position when finished.
3. Gasoline to Propane/LPG Conversion:
- Connect the LPG gas hose to the propane fuel source.
- Ensure the propane tank is fully closed.
- Fully open the Propane/LPG cylinder knob.
FAQ
Q: Can I use the generator indoors?
A: No, using the generator indoors can be fatal due to carbon monoxide poisoning. Always operate the generator outside in a well-ventilated area.
Generator Quick Start Guide
Unpack Generator: Remove generator, accessories, inserts and Literature from carton. If any item is missing or damaged, contact our product service department at 855-888-3598.
WARNING
This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and underdstand the operator’s manual before using this product. All pages references to the operator’s manual.
- Add Lubricant and Fuel
- Remove the maintenance cover and use a funnel to pour 10W-30 engine oil into engine. Fill to the upper mark of the oil dipstick H.
- Start Generator
- Move the generator outside to a flat, level surface, away from doors, windows and vents.
DANGER
Using a generator indoors can kill you in minutes. Generator exhaust contains carbon monoxide. This is a poison you cannot see or smell
- never use inside a home or garage, even if doors and windows are open.
- only use outside and far away from windows, doors and vents
WARNING Do not overload the generator or electrical cords. Consult operation manual
Select the Fuel Source (Gasoline)
-
Add gasoline to the fuel tank.
-
Make certain the propane tank is fully closed.
-
Turn the starting dial switch to the START N position.
Note: For restarting a warm engine, turn the starting dial switch directly to the “RUN” position -
Pull recoil starter slowly until resistance is felt, then pull rapidly
-
Turn the starting dial switch to the RUN position
-
Plug in items to be powered, using only grounded extension cords
Select the Fuel Source (Propane/LPG)
- Connect the LPG gas hose to the propane fuel source.
- Fully open the Propane/LPG cylinder knob
- Turn the starting dial switch to the START N position.
- Pull the recoil starter twice.
- Turn the starting dial switch to the RUN position
- Pull the recoil starter slowly until resistance is felt, then pull rapidly.
- Plug in items to be powered, using only grounded extension cords.
Shutdown and Storage
- Remove any load from the generator.
- Turn the starting dial switch to the OFF position
- Turn the fuel valve knob to the OFF position
If generator is to be stored for longer than 30 days, refer to the operator’s manual for further Instruction.
-
Disconnect all electrical loads from the generator
Gasoline to propane/LPG -
Connect the LPG gas hose to the propane fuel source.
-
Fully open the Propane/LPG cylinder knob
Propane/LPG to Gasoline -
Make certain the propane tank is fully closed
-
Questions?
- Call
- 855-888-3598 or
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>