Kraus KPF-2600 Oletto Single Handle Kitchen Bar Faucet Instruction Manual
- May 15, 2024
- Kraus
Table of Contents
Kraus KPF-2600 Oletto Single Handle Kitchen Bar Faucet
Congratulations on the purchase of your new Kraus plumbing fixture! Please keep the box and packaging materials until your product is completely installed. If you have any questions, require technical assistance, or have any problems with your product:
- STOP DO NOT RETURN TO STORE
Please contact our Customer Service at 1-800-775-0703 / [email protected] the model number available and retain a copy of your receipt with the purchase date for reference. If for any reason this product does not meet your expectations, please be sure to repack this product in the original box and packaging material to avoid damage during transit.
Before Installation:
- Make sure you have all necessary parts by checking the diagram and parts list. If any part is missing or damaged, please contact Kraus Customer Service at 800-775-0703 for a replacement.
- Read all instructions and safety warnings and ensure you have all the tools, parts, and equipment necessary for a safe installation.
- Turn off the hot and cold water supply at the angle stops and turn on the old faucet to release any built-up pressure. Remove the existing faucet.
- Pre-drilled hole size requirement: 1 3/8″ (min)
- Max countertop thickness: 2 3/8”
For technical assistance or replacement parts, please contact Kraus Customer Service and one of our representatives will be happy to help: Toll-Free: 800-775-0703 or [email protected]
Tools Required
Care & Maintenance
- To keep the product clean & shining, follow the steps below:
- Rinse with clean water & dry with a soft cloth
- Do not clean with soaps, acid, polish, abrasives or harsh cleaners
- Do not use cloth with a coarse surface
- Unscrew the aerator and clean it when necessary
- This installation manual is subject to change without further notice.
Diagram and Parts List
- A. Faucet Body
- B. Easy Install Assembly
- C. 6mm Hex Wrench
- D. 2.5mm Hex Wrench
Faucet Dimensions
Installer Tip: Shut off main water supply before installing new faucet.
Step 1a: Installing the easy install assembly
Shut off the water supply. Remove the old faucet. Clean the mounting
surface. Check for the proper thickness of the sink or countertop. Insert the
base (a) into the sink or countertop. If your model does have an escutcheon,
skip to step 1 b.
NOTE: “Front” on the base (a) must face the front of the sink or countertop. The two mounting plates (b)b) on the base (a) must be loose and movable during the installation of the base (a).
Step 2: Installing the easy install assembly
Press the base (a) so that it can not move, then turn the screw with the provided hex wrench (C, HEX: 6.0mm) clockwise, as shown in Fig 1. When the mounting plates (b) make contact with the sink (1), continue to turn the screw with the provided hex wrench (C, HEX: 6.0mm) clockwise, as shown in Fig 2, until the base (a) is completely tightened and secured, as shown in Fig 4.
Step 3: Installing the faucet
Insert the supply lines (1) through the hole of the base (a). Carefully insert the hoses into the base. Place the faucet assembly (A) onto the base (a) as shown in the above figure. Secure the faucet assembly (A) by tightening the set screw with the provided hex wrench (D, Hex: 2.5 mm).
Step 4: Connect waterlines to the main valve
Attach waterlines to angle stops and tighten until snug. Turn on angle stops and check for leaks (DO NOT TURN FAUCET ON).
NOTE: Please make sure filter washers are installed before connecting to the main valve.
Step 5: Flush faucet
After installing the faucet, remove the aerator. Turn the water on for 30
seconds to remove any debris. Reassemble the aerator. Do not lose the gasket
(1) in the aerator.
Replacement Parts
| | |
17
| | | | | Replacement Parts List| Finish / Color| Part #|
---|---|---|---|---|---|---|---|---|---|---|---
| | | | | | | 1. Aerator Assembly| CH, SFS, MB,| KP27295|
| | | | | | | BB, SFACB|
| | | | | | | 2. Washer| GR, BL| KP27031|
| | | | | | | 3. Block| | KP27030|
| | | | | | | 4. O-Ring| | KP27029|
| | | | | | | 5. Index| GR, BL*| KP27222|
| | | | 5| | | 6. Set Screw| | KP27033|
| | | | 6| | |
7. Cartridge| | KP27257|
| | | 7| ****
8
| ****
9
| |
8. Bonnet Nut| | KP27258|
| | | | ****
14
| | 10
11
12
15
| 9. Cap| CH, SFS, MB,
BB, SFACB*
| KP27259|
10. Handle| CH, SFS, MB,
BB, SFACB*
| KP27260|
11. Set Screw| | KP27001|
| | | | 16| | |
12. Cover Button| GR, BL*| KP27002|
| | | | | | | 13. O-Ring Set of 2| | KP27171|
| | | | | | | 14. Easy Install Assembly| | KP27262|
| | | | | | | 15. Hex Wrench 2.5mm| | KP27020|
| | | | | | | 16. Hex Wrench 6mm| | KP27263|
| | | | | | | 17. Filter Washer| | KP27167|
- Denotes faucet component color options:
- SFS – Spot Free Stainless Steel
- CH – Chrome
- GR – Grey
- BL – Black
- MB – Matte Black
- BB – Brushed Brass
- SFACB – Spot Free Antique Champagne Bronze
Troubleshooting
If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps:
PROBLEM
|
CAUSE
|
ACTION
---|---|---
Leakage under the handle.| Bonnet nut (8) has come loose.| Remove the cover
button (12). Loosen the set screw (11) with the hex wrench (15). Remove the
handle (10) and cap
(9) . Tighten the bonnet nut (8) with an adjustable wrench.
The aerator has an irregular or reduced water flow.| The aerator is dirty or
misfitted.| Remove the aerator and check for debris. Ensure that the rubber
washer is properly installed.
The water will not shut off completely.| The cartridge may need to be adjusted
or replaced.| Remove the cover button (12). Loosen the set screw (11) with the
hex wrench (15). Remove the handle (10) and cap (9).
Loosen the bonnet nut (8) with an adjustable wrench. Remove the cartridge (7). Check for cracks.
There is a low flow of water.| The filter washers in the hose connectors are dirty.| Turn off the water supply at the water valves and unscrew the hose connectors from the water supply lines. Clean the filter washers in the water lines with hot water, removing any debris or calcium buildup.
Codes/Standards Applicable
Faucet – Lifetime Limited Warranty
Kraus USA Plumbing, LLC (“Kraus”) extends this warranty to the original
purchaser for personal household use of the Faucet when purchased from an
authorized Kraus dealer and in the location of original installation. This
warranty is non-transferable. Kraus warrants the structure and finish of the
Faucet to be free from defects in material and workmanship under normal usage
for as long as the original purchaser resides in the residence in which the
Faucet was first installed. Kraus warrants the Faucet’s sprayhead assembly
(including the engine, aerators, structure, restrictors, backflow preventers,
sprayer hoses, and braided supply line hoses which encompasses nylon, silicon
and stainless steel) of the product to be free from defects in material and
workmanship under normal usage for one (1) year from the date of purchase.
Kraus warrants the Faucet’s cartridge to be free from defects in material and
workmanship under normal usage for a period of five (5) years from the date of
purchase. Any product reported to the authorized dealer or to Kraus as being
defective within the warranty period will be repaired or replaced with a
product of equal value at the option of Kraus.
Commercial Warranty
Kraus USA Plumbing, LLC (“Kraus”) warrants its Products for one (1) year to
commercial purchasers of Products used in industrial, commercial and business
applications.
Care and Cleaning Instructions
Certain cleaning products may cause damage to a Product’s finish and use of
the following on the Product will void this
warranty:
Abrasive cleaners such as powders, bleach, ammonia, alcohol or chorine
Abrasive pads, steel wool or wire brushes
What is Not Covered
This warranty does not cover Products that were discontinued when purchased or
display Products, whether such Products were purchased at discount outlets,
unauthorized dealers, and/or sold on clearance. This warranty does not cover
any free gifts included with purchase. This warranty does not cover damage
resulting from neglect, misuse (including use for an unintended application),
abuse, carelessness, accident, hard water or mineral deposits, exposure to
corrosive materials, improper maintenance, alteration of the Product, or
failure to follow care, cleaning or installation instructions enclosed with
your Product. Kraus recommends that all Kraus Products be installed by a fully
licensed and insured trade professional with experience in the installation of
bathroom and/or kitchen manufactured goods.
How to Make a Warranty Claim
R If you are a consumer purchaser, please contact a Kraus Customer Service
Representative at:
- Kraus USA Plumbing, LLC
- 12 Harbor Park Drive
- Port Washington, NY 11050
- Toll-free 800-775-0703
- [email protected]
If you are a plumbing contractor or trade professional, please contact a Kraus Pro Representative at:
- Kraus USA Plumbing, LLC
- 12 Harbor Park Drive
- Port Washington, NY 11050
- 516-801-8955
- [email protected]
If you are an authorized partner, please contact a Partner Support Representative at:
- Kraus USA Plumbing, LLC
- 12 Harbor Park Drive
- Port Washington, NY 11050
- 516-801-8954
- [email protected]
In requesting warranty service, please be ready to provide your proof of purchase and a description of the problem. Shipping charges will be covered for the first (1) year of the warranted replacement part or product (HI, AK, and Puerto Rico shipping charges may apply). International shipping fees are not included.
Limitation on Duration of Implied Warranties
Please note that some states/provinces (including Quebec) do not allow
limitations on how long an implied warranty lasts, so the below limitations
may not apply to you. TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, ANY
IMPLIED WARRANTY, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND OF
FITNESS FOR A PARTICULAR PURPOSE, IS LIMITED TO THE STATUTORY PERIOD OR THE
DURATION OF THIS WARRANTY, WHICHEVER IS SHORTER.
Limitation of Special, Incidental, or Consequential Damages
Please note that some states/provinces (including Quebec) do not allow the
exclusion or limitation of special, incidental, or consequential damages, so
the below limitations and exclusions may not apply to you. TO THE MAXIMUM
EXTENT PERMITTED BY APPLICABLE LAW, THIS WARRANTY DOES NOT COVER, AND KRAUS
USA PLUMBING, LLC SHALL NOT BE LIABLE FOR, ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES (INCLUDING LABOR CHARGES TO REPAIR, REPLACE, INSTALL, OR
REMOVE THIS PRODUCT), WHETHER ARISING OUT OF BREACH OF ANY EXPRESS OR IMPLIED
WARRANTY, BREACH OF CONTRACT, TORT, OR
OTHERWISE.
This warranty gives you specific legal rights, and you may also have other rights that vary from state/province to state/province.
Download the Kraus Care & Maintenance Guide at: http://www.kraususa.com/maintenance
Register Your Kraus Product
- Activate Your Warranty
- Access Premium Customer Support
- Get Product Information
REGISTER TODAY
References
- Kraus | Kitchen and Bathroom | Sinks, Faucets, and Accessories
- Care & Maintenance | Well-crafted products | Light maintenance.
- Kraus USA Self Help