Radium RFXA0614 24V DC LED Essence Strip Light User Manual
- June 4, 2024
- Radium
Table of Contents
Radium RFXA0614 24V DC LED Essence Strip Light
Description
Specification
Max. meters of LED STRIP at 24V DC.
Max. meters of LED STRIP at 24V DC 1)| Alu profile for heat
dissipation needed?
---|---
LED STRIP 500 E| 7 m| No
LED STRIP 1000 E| 5,5 m| No
LED STRIP 1500 E| 5 m| No
LED STRIP 1000 E RGB| 5 m| Yes
LED STRIP 2200 E TW| 5 m| Yes
Installation
Before soldering, tin-plate the cable and solder pads first and solder for
max. 3s at 350°C; before every further soldering step, allow the solder point
to completely cool down; prevent peeling or shearing forces. The module is
mounted using the double-sided adhesion tape on the reverse. Ensure the
surfaces are clean and free of grease, oil, silicone, and dirt particles.
Ensure the protective tape is completely removed. If mounted to metallic
surfaces, apply insulation between the mounting surface and the module to
prevent short circuits at the solder contact points. The module needs to be
mounted to a thermally conductive surface to ensure that Tc is not exceeded.
Protect against mechanical and electrostatic loads when mounted.
Wiring
Guarantee
Ensure that the mounting surface is clean and smooth. This guarantees that the allowed operating temperatures are not exceeded. Module mounted to a thermally conductive surface.
Radium Lampenwerk GmbH
Dr.-Eugen-Kersting-Straße 6 51688 Wipperfürth GERMANY
www.radium.de. V2105.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>