Radium RL-T8 18 S MS 840-G13 EM LED Star Tube T8 Motion Sensor Instruction Manual

: June 12, 2024
: Radium

Table of Contents

Installation Instructions
Specification
Dimension
Customer Support
Documents / Resources

Radium RL-T8 18 S MS 840-G13 EM LED Star Tube T8 Motion Sensor

Installation Instructions

Specification

|

Replacement of conventional T8 fluorescent tube on CCG1)

|

Maximum case temperature2) (Tc)

|

Storage temperature3) (Ts)

|

Ambient temperature4) (Ta)

---|---|---|---|---
RL-T8 18 S MS 840/G13 EM|

0.6 m

|

60°C

|

-20° … 80°C

|

-20° … 50°C

RL-T8 36 S MS 840/G13 EM|

1.2 m

RL-T8 58 S MS 840/G13 EM|

1.5 m

|

65°C

Operating frequency: 5.725-5.875GHz; Maximum transmitting power: 0.5mW5)

Dimension

LED Star Tube T8 Motion Sensor detection area 6)

h| r
2.5 m| 4.5 m
3.0 m| 5.0 m
4.0 m| 4.5 m
4.5 m| 4.0 m
5.0 m*| 4.0 m

*maximum recommended mounting height 7)

This lamp is designed for general lighting service (excluding for example explosive atmospheres). Since only lamp and starter are replaced there is no constructive modification to the luminaire. This lamp may not be suitable for use in all applications where a traditional fluorescent lamp has been used. The temperature range of this lamp is more restricted. In cases of doubt regarding the suitability of the application the manufacturer of this lamp should be consulted. 5.8 GHz Microwave Sensor included. After 5 minutes lamp dims down to 20% light. After additional 2 minutes lamp will switch off completely.
Hereby, Radium Lampenwerk GmbH declares that the radio equipment type LED Star Tube T8 Motion Sensor Device is in compliance with Directive 2014/53/ EU. The full text of the EU declaration of conformity is available at the following internet address: www.radium.de/ui
Radio Frequency Interface Requirements – Related to European installation.
Note: This equipment has been tested and found to comply with the limits for a EN 300 440 v2.1.1 receiver Category 3.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.

Replacement of conventional T8 fluorescent tube on CCG. 2) Maximum case temperature. 3) Storage temperature. 4) Ambient temperature. 5) Operating fre- quency: 5.725-5.875GHz; Maximum transmitting power: 0.5mW. 6) LED Tube MOTION SENSOR detection area. 7) maximum recommended mounting height.
Lamp to be used in dry conditions or in a luminaire that provides protection.
Lamp suitable for 50Hz or 60Hz operation. 10) Lamp not suitable for emergency operation. 11) Dimming not allowed. 12) LED replacement starter.

| | |
---|---|---|---

Lamp to be used in dry conditions or in a luminaire that provides protection8)

|

Lamp suitable for 50Hz or 60Hz operation9)

|

Lamp not suitable for emergency operation10)

|

Dimming not allowed11)

Customer Support

LED replacement starter12)

Radium Lampenwerk GmbH
Dr.-Eugen-Kersting-Str.6
51688 Wipperfürth Germany
1688 Wipperfürth Germany
www.radium.de

Documents / Resources

| Radium RL-T8 18 S MS 840-G13 EM LED Star Tube T8 Motion Sensor [pdf] Instruction Manual
RL-T8 18 S MS 840-G13 EM LED Star Tube T8 Motion Sensor, RL-T8 18 S MS 840-G13 EM, LED Star Tube T8 Motion Sensor, Star Tube T8 Motion Sensor, Tube T8 Motion Sensor, T8 Motion Sensor, Motion Sensor, Sensor
---|---