Nilight 3500 Quad Headlamp Assembly Replacement User Manual
- June 17, 2024
- Nilight
Table of Contents
Headlight Assembly
User Manual
COMMON CAUSES OF HEADLIGHT CONDENSATION
- Large changes in daily temperature
- Leaking seals on bulbs and/or bulb sockets
- Headlight turned on and the bulbs heats up inside the housing. the hot air will turn into moisture
HOW TO SOLVE:
- Check that all vents are free from blockages. Turn on the low beam for 20 mins to raise the headlight temperature and evaporate condensation.
- Remove bulbs to allow moisture to evaporate from inside the housing. Heat with a hairdryer to speed up the process.
- Leaking seals on bulbs or bulb sockets. Put moisture-absorbing silica-gel desiccant packet inside the headlight.
Proper Connection
Inproper Connection
Seal it with Silicone
INSTALLATION STEPS:
- Remove the grille. Undo the screws, clips, or retainer springs that hold the headlight in place, Remove the fasteners that are typically located at the top and bottom of the headlight.
- Disconnect the wiring from the stock headlight and detach the stock headlight.
- Fit in Nilight Headlight and fix it into place and make sure that the screws, clips or retainer springs used are sealed.
- Reconnect the wiring that was unplugged from the assembly.
- Put back the grille and seal them back into place.
Highly Recommend Professional Installer for Installation
HIGH I LOW BEAM ANGLE ADJUSTABLE
NOTE: The headlights have been adjusted to the best beam angle when leaving the factory. and there is generally no need to manually adjust the beam angle. If you want to adjust. please follow below instructions:
- High/Low Beam Adjuster
For vertical beam adjustment, please use the screwdriver to rotate the adjuster gear gently, no more than 3 times either clockwise/counterclockwise.
DO not adjust over 3 times or the adjuster Will be damaged!
Documents / Resources
|
Nilight 3500 Quad Headlamp Assembly
Replacement
[pdf] User Manual
3500 Quad Headlamp Assembly Replacement, 3500, Quad Headlamp Assembly
Replacement, Headlamp Assembly Replacement, Replacement
---|---