VISUAL COMFORT S5177 Presidio Large Linear Lantern Instruction Manual
- June 4, 2024
- VISUAL COMFORT
Table of Contents
ASSEMBLY INSTRUCTIONS
COMFORT S5177 Presidio Large Linear Lantern
Instruction Manual
S5177 Presidio Large Linear Lantern
Presidio Large Linear Lantern
Item # S 5177
NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with its construction and operation of it, as well as the hazards involved. Inspect items and contents carefully. If any damage or defect is found, do not install it. Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
| Phillips Screwdriver | Slotted Screwdriver | Wire Strippers |
|---|---|---|
| Wire Cutters | Hammer | Pencil |
Drill
PERSONS REQUIRED: Two
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from the canopy (G) by removing the collar ring (H).
-
Using the mounting plate (B) as a guide, line up with the ceiling and mark anchor positions.
-
Using a drill bit slightly smaller than the anchor, drill holes in the marked positions. Install anchors (A) into the holes using a hammer.
-
Install mounting plate (B) to the junction box and secure with mounting screws (C), then secure wood screws (D) to anchors (A).
-
Install canopy (G) to mounting plate (B) by securing with collar ring (H).
-
Place top glass shades (J) onto top glass holders.
NOTE: It is recommended to have a helper assist in supporting the fixture for steps 8-9. -
Feed fixture wire and ground wire through bottom rods (I) and top rods (F).
-
Connect bottom rods (I) to top rods (F), then attach to fixture loops (K) and hooks (E). Secure links (P) at the ends of rods.
NOTE: Ensure there is no tension on the wires. Cut excess wires, being sure to leave enough to reach the junction box. -
Separate two sides of the molded wire, and strip insulation on each 5/8″.
-
Loosen collar rings (H) and let canopy (G) slip down rods carefully.
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (Q).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (ribbed) to the supply neutral wire (usually white) using wire nut (Q).
-
Connect the fixture hot wire (smooth with markings) to the supply hot wire (usually black) using a wire nut (Q).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck them into the junction box.
-
Install canopy (G) to mounting plate (B) by securing with collar ring (H).
-
Remove rubber washers (N) and socket rings (Q) from the sockets, then install glass shades (M) to socket holders and secure them with rubber washers (N) and socket rings (Q).
NOTE: Do not overtighten otherwise shade could become damaged. -
Install light bulbs into the sockets.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>