AUTOSAVER88 2002-2023 Soft Roll Up Truck Bed Tonneau Cover Instruction Manual
- June 17, 2024
- AUTOSAVER88
Table of Contents
AUTOSAVER88 2002-2023 Soft Roll-Up Truck Bed Tonneau Cover
Part List
Installation
Clean the truck bed thoroughly before installation.
-
Stick the supplied front seal strip on the front bed rail by aligning with the outer edge.
Install the provided LED lamps according to the actual situation of the truck bed.
ATTENTION!
IF THE TRUCK’S FRONT BED RAIL IS LOWER THAN THE SIDES, USE THE PROVIDED WEATHER SEAL STRIPS. GAPS ON THE FRONT BED AND TAILGATE WILL CAUSE NOISE AND FLAPPING ISSUES WHILE THE VEHICLE IS IN MOTION! -
Insert Side Rails (L&R)into the front rail of the front end. Make sure the Side Rails are parallel and all placed on the bed rails.And check that the reserved positions of Side Rails and bed Rails are the same.
ATTENTION!
MAKE SURE THE SIDE RAIL LINES UP WITH THE INNER EDGE OF THE TRUCK BED RAIL. PLACE THE SIDE RAILS EVENLY SO THAT THE DISTANCE BETWEEN THE REAR END OF THE SIDE RAIL TO THE TAILGATE IS THE SAME ON BOTH SIDES -
POSITIONING SIDE RAILS
- THEN EVENLY PLACE THE SUPPLIED CLAMPS ALONG THE SIDE RAILS ACCORDING TO THE POSITIONAL CONFIGURATION A/B BASED ON THE # OF CLAMPS.
- ATTACH THE CLAMPS TO THE SIDE RAIL AND THE TRUCK BED RAILS. DO NOT TIGHTEN CLAMPS UNTIL THE COVER IS PROPERLY FITTED.
- ATTENTION!
NOTE : FOR TOYOTA NISSAN JEEP MODELS, (EXCL. NISSAN FRONTIER REFER TO PAGE 8 FOR SUPPLEMENTAL INSTRUCTION ON UTILITY TRACK BRACKET INSTALLATION.
-
Slide the front clamp to the best position, clamp the interface under the metal bed rail point, and then use the Triangle screw to rotate into the metal rod to fix the entire clamp.
-
Untie the spring cords on both sides of the bed cover and untold the bed cover to ensure correct and neat coverage of the entire lathe.
-
Snap the tail lock into the lock groove of the side rails as shown
-
Press down to close the cover and the lock will automatically clamp.
-
FINISH THE INSTALLATION
Tighten the velcro on both sides of the bed make the cover more docile and overall, and finally complete the installation.
NOTE: COVER MAY NOT COMPLETELY COVER TO THE OUTSIDE EDGE OF THE BED RAILS DUE TO SLIGHT DIFFERENCE IN TRUCK BED SHAPE FOR DIFFERENT YEAR MODELS -
Open the tailgate, pull down the rope,and the lock will automatically open.
-
Roll up the tarp and buckle the spring cord to enjoy plenty of bed space.
-
There is a scale label on the tail of the side rail.If you find that the bed covertarp is loose,you can move the tail lock backwards according to the situation. Will make the tarp tighter.
-
SUPPLEMENT TO INSTALLATION INSTRUCTIONS (Only for models with system track EXCL.NISSAN FRONTIER)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>