AUTOSAVER88 MAAUTfBs7w Soft Roll Up Tonneau Cover Installation Guide
- June 15, 2024
- AUTOSAVER88
Table of Contents
SOFT ROLL UP TONNEAU COVER
INSTALLATION
**GUIDE
**
PARTS LIST
| ITEM | DESCRIPTION | QTY. |
|---|---|---|
| 1 | Bed cover | 1 |
| 2 | Side Rails(L&R) | 2 |
| 3 | Seal strip 118(in) | 1 |
| 4 | G clamp | 6 |
| 5 | Light | 1 |
| 6 | screw | 6 |
| 5 | hexagonal wrench | 1 |
-
Clean truck bed thoroughly before installation.
. Stickthe supplied front seal strip on the front bed rail by aligning with the outer edge. -
Insert Side Rails (L&R) into the front rail of the front end. Make sure the Side Rails are parallel and all placed on the bed rails. And checkthat the reserved positions of Side Rails and bed Rails are the same.
-
Slide the front clamp to the best position, clamp the interface under the metal bed rail point, and then use the Triangle screw to rotate into the metal rod to fix the entire clamp
-
Untie the spring cords on both sides of the bed cover and unfold the bed cover toensure correct and neat coverage of the entire lathe
-
Snap the tail lock into the lock groove of the side rails as shown
-
Press down to close the cover and the lock will automatically clamp.
-
FINISH THE INSTALLATION
«Tighten the velcro on both sides of the bed cover. Make the cover more docile and overall, and finally complete the installation.
COMPLETED!!! NOTE : COVERMAY NOT COMPLETELY COVER TO THE OUTSIDE EDGE OF THE BED RAILS DUE TO SLIGHT DIFFERENCE IN TRUCK BED SHAPE FOR DIFFERENT ‘YEAR MODELS -
Open the tailgate, pull down the rope, and the lock will automatically open.
-
Roll up the tarp and buckle the spring cord to enjoy plenty of bed space.
-
There isascale label on the tail of the side rail. If you find that the bed cover tarpis loose, you can move the tail lock backwards according to the situation. Will make the tarp tighter. SPECIAL INSTRUCTIONS FOR ALTERNATIVE BRACKETS SUPPLEMENT TO INSTALLATION INSTRUCTIONS (Only for models with system track)
-
Slide aluminum blocks into track from the front ‘
-
After moving to the right position, snap on the F-clipt
-
Fixed two screwst
-
Complete the installation