CONDOMOUNTS CLMMMAW2022 Full Motion Pillar Monitor Mount Instruction Manual
- June 17, 2024
- CONDOMOUNTS
Table of Contents
Column Monitor Mount
US PATENT NO. US11221102B2 CLMMMA2022
CLMMMAW2022 Full Motion Pillar Monitor Mount
Installation Videohttps://youtu.be /SACW-tFZ0JY
Need Help? Contact our pros:
647-557-5699
support@condomounts.com
condomounts.com
WARNING STATEMENTS
Warning
Prior to the installation of this product, the installation instruction
must be read and completely understood. Failure to do so may result in
personal injury, property damage or voiding of manufacturer warranty.
Pay attention to the weight capacity of the mount. Exceeding the limitation
can result in impairment or serious injury and property damage.
Never operate the mount if parts are missing or damaged.
Do not use this product for any purpose or in any configuration not explicitly
soecified in this instruction. We hereby disclaim any and all liability for
injury or damage arising from incorrect assembly, incorrect mounting, or
incorrect use of this product.
PRODUCT LINE GRAPH
PARTS AND HARDWARE
STEP 1: ATTACH COLUMN MOUNTING BRACKET TO POST/COLUMN
Hold column mounting bracket to the column where you would like fo mount the monitor
Ask a second person to wrap the strap around the column
Person #2 should insert free end of strap into the slot of the ratchet buckle
4a. Bring the ratchet buckle snug to the column and pull the strap tight.
Ab. Crank the handle to tighten the strap until if feels taut and secure.
4c. Close the buckle fo lock if.
4d. Repeat steps a, b and c for the bottom strap.
Cut extra strap or fold and tuck away.
TO MAKE ADJUSTMENTS AFTER INSTALLATION
TV too high? Too low? Not centered? No problem!
HOW TO ADJUST THE POSITION OF THE COLUMN MOUNTING BRACKET
CAUTION:
Do not adjust the column mounting bracket while the TV is mounted
a. To release the strap pull, and hold the lever towards the handle, then
rotate the handle all the way fo position C.
b. Move your column mounting bracket to the new desired position and tighten.
Need Help? Contact our pros:
647-557-5699
support@condomounts.com
condomounts.com
STEP 2: ATTACH ARM TO COLUMN BRACKET
Insert the Extention Arms to the wall plate and Put Spring Arms onto the extension arm.
STEP 3: ATTACH MONITOR TO ARM
Attach adaptors if 200 x 200 VESA Is required.
Flush Surface Installation: Install 4 screws through faceplate to monitor
via mounting holes.
Recessed Surface Installation: Put 4 soacers between faceplate and
monitor. Install 4 screws through faceplate, soacers to monitor via mounting
holes.
Lift the VESA plate along with monitor and put it on head slot.
ADJUSTMENTS
GAS SPRING TENSION ADJUSTMENT
**** Be sure to keep the arm in horizontal position during adjustment. Or else, it would be difficult to adjust the mount.
1 turn ≈ 1 Ibs ≈ 0.4kg
NOTE: Turn clockwise to reduce tension for lighter monitors and counter-
clockwise to increase tension for heavier monitors.
Use a hex wrench to adjust the height tension of the gas spring arm after the
monitors are installed, to keep different weight of monitors still at any
position.
TILT & SWIVEL ADJUSTMENT
Tighten the bolt with the Allen Key to make the tilt and swivel adjustment.
MANAGE CABLES
Route the cables along the mounting arm.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>