CONDOMOUNTS MSK9002 Tiled Wall TV Mounting Kit User Guide

CONDOMOUNTS MSK9002 Tiled Wall TV Mounting Kit

Product Information

Specifications

• Compatible Surfaces: Tile, Granite, Marble, Drywall, Backer Board Wall
• Mounting Method: Toggle Bolt
• Mounting Hole Size: 1/2 inch
• Toggle Bolt Size: 3/16 inch

Product Usage Instructions

Step 01: Marking Mounting Holes

1. Mark the desired mounting hole locations on the wall.
2. Cover the surface area around each hole with painters’ tape to protect it from scratches caused by the drill bit slipping.

Step 02: Drilling Hole on Tile

1. Hold the drill tightly in position.
2. Press gently on the tile surface to create a groove.
3. Slowly extend the groove to form a hole.
4. To start drilling on the glossy tile surface, begin at a 30-degree angle to the surface.
5. Frequently pause from drilling and dip the tip of the drill bit in water to prevent overheating and damage to the bit.
6. Once the bit starts cutting, keep the drill speed slow and steady.
7. Pivot the drill to 45, 60, and 90 degrees and continue drilling.
8. When at a 90-degree angle, continue drilling slowly until you penetrate the backing board and create a clean hole.

Step 03: Inserting Toggle Bolt

1. Insert the toggle bolt into the hole created.

Step 04: Inserting Screws and Tightening

1. Insert the screws into the mounting flange.
2. Tighten the screws securely to ensure proper installation.

Frequently Asked Questions (FAQ)

• Q: What surfaces are compatible with this product?
  A: This product is compatible with Tile, Granite, Marble, Drywall, and Backer Board Wall surfaces.

• Q: What size of mounting hole should be drilled?
  A: The recommended mounting hole size is 1/2 inch.

• Q: What size of toggle bolt is required?
  A: A 3/16 inch toggle bolt should be used for mounting.

Tile / Granite / Marble / Drywall / Backer Board Wall

1. Step 01
   Mark mounting holes on the wall. Cover the surface area around the hole with painters’ tape to shield area from scratches by slipping drill bit.

2. Step 02
   Drill Hole on Tile. Hold the drill TIGHT in position and press gently on tile surface to create a groove then slowly extend the groove to a hole.

   • The hardest part of drilling this surface is the start. Start drilling at a 30-degree angle to the surface. The goal is it to start etching the glossy surface.
   • Frequently pause from drilling and dip the tip of the drill bit portion in water. This is to avoid overheating the drill bit and ruining the tip.
   • Once bit starts to cut, keep the drill slow and steady. Pivot drill to 45, 60 and 90 degrees and continue drilling.Once at 90 degrees continue slowly till you penetrate the backing board to make a nice hole.
   • For best results:
     Practice on test material first. Lubricate tip with water. Slow speed and minimum pressure.

3. Step 03
   Insert Toggle bolt.

4. Step 04
   Insert screws and tighten.

Scan to Watch https://shorturl.at/lGT23

References

• How does the thickness of the wire affect? – TeachersCollegesj

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>