SEALEY SS3 8L Pressure Sprayer User Guide
- June 4, 2024
- SEALEY
Table of Contents
SS3 8L Pressure Sprayer
User Guide
SS3 8L Pressure Sprayer
8L PRESSURE SPRAYER
MODEL NO: SS3
Thank you for purchasing a Sealey product. Manufactured to a high standard,
this product will, if used according to these instructions, and properly
maintained, give you years of trouble-free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE
OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND
WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE
INSTRUCTIONS SAFE FOR FUTURE USE.
| Refer to instructions
---|---
| Wear eye protection
| Wear protective gloves
| Wear a mask
SAFETY
NOTE! This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. The Sealey Hand Pressure Sprayer Model No SS3 is safe and only becomes a safety issue when used with toxic fluids. The following safety instructions are bulletin points and cannot cover every aspect of user safety.
Be aware of the safety requirements (C.O.S.H.H.) for the fluids contained in
the vessel.
Wear safety equipment as advised in (C.O.S.H.H.) statements.
Do read and follow all the fluid manufacturer’s instructions for application
and safe use.
Store the vessel inside an outbuilding away from foodstuffs and out of reach
of children.
Label the vessel with the chemical used, even if water. It is highly
recommended that individual vessels should be used for individual chemicals.
Cross-contamination can give unexpected results. Also, possible spillages are
avoided in transferring liquids.
X DO NOT spray at people, animals, protected insect species, in high
winds, at naked flames or sources of heat.
X DO NOT use the pressure sprayer for any purpose other than for which
it is designed.
X DO NOT use whilst eating, drinking, smoking; under the influence of
drugs, alcohol, intoxicating medication, or if fatigued.
X DO NOT use to spray flammable liquids, solvents, etc..
INTRODUCTION
Ideal for spraying a wide variety of fluids including water, herbicides, pesticides, insecticides, fungicides, and solvent-free preservative treatments. Metal lance with an adjustable nozzle that can be switched between mist and jet settings. Fitted with an adjustable shoulder strap and pressure relief valve.
OPERATION
3.1. Grip the dual-purpose handle (A) and engage with drive tangs on the
filler cap (B), holding the vessel that rotates the filler cap to remove.
3.2. Avoiding spillages fill to 8L maximum or required volume.
3.3. Re-attach the filler cap, keeping the vessel vertical. With the dual-
purpose handle, engage with tangs on the filler cap, holding the vessel rotate
until the filler cap is hand-tight against the neck seal.
3.4. Attach a label with the contents indicated.
3.5. Pressurise (A) as shown in the illustration. Pressure can be reduced
manually via the spring return pressure release valve (C).
3.6. Operate the trigger (E) to spray and rotate the nozzle (D) to obtain
desired spray mode, rotate the nozzle fully to close.
3.7. After use, operate the pressure relief valve to de-pressurize the vessel.
3.8. Flush externally with water to clean off residuals and store safely after
use.
ENVIRONMENT PROTECTION
** Recycle unwanted materials instead of disposing of them as waste. All
tools, accessories, and packaging should be sorted, taken to a recycling
center, and disposed of in a manner that is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain
any fluids (if applicable) into approved containers and dispose of the product
and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we
reserve the right to alter data, specifications, and component parts without
prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty:** The guarantee is 12 months from the purchase date, proof of
which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business
Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
[email protected]
www.sealey.co.uk
© Jack Sealey Limited
Original Language Version
SS3 Issue 4 (3) 01/06/2021