NOLAN D-RINGS Full Face Helmet Instruction Manual
- June 17, 2024
- NOLAN
Table of Contents
D-RINGS
INSTRUCTIONS FOR USE
“D-RINGS” RETENTION SYSTEM
Your new helmet is equipped with the D-ring retention system.
To ensure maximum protection and enjoy the advantages of the D-ring retention
system, carefully read and follow the instructions on this label.
In order to prevent improper use of the helmet and, in particular, to prevent
it from being incorrectly fastened, the ECE 22-06 approval standard requires
that the helmet be put on and removed without having to unthread the band
completely from the rings.
For this reason, this retention system, which is only efficient when the
band is threaded correctly in the rings as illustrated in Fig. 1 , is
supplied pre-fastened and is conceived in such a way as to limit closing and
opening to simple adjustments of the tightness of the band.
Therefore it is supplied with:
– a band end fitted with the male side of a snap button that prevents the
retention system from opening completely, and once the tightness is adjusted,
prevents it from fluttering when it is fastened to the female side;
– a red quick release flap that facilitates the loosening of the retention
system.
To put on the helmet:
– Unhook the snap button by pulling on the band end (see Fig. 2).
– Pull the red quick release flap until the band is loosened completely
without unthreading it from the rings (see Fig. 3).
– With the help of your thumbs, bring the pre-fastened chin band towards the
forward part of the helmet so that it does not get in the way of your face
while the helmet is being put on.
– Put on the helmet ensuring that it is the correct size for you (see the
attached instruction leaflet).
– Pull the band end (see Fig. 1) until you feel the band tightly pressed
against your jaw.
– Refasten the snap button on the band end (see Fig. 2).
– Now try to remove the helmet by taking hold of it by the rear edge and
rotating it forward. The helmet should remain well fitted on your head (see
the attached instructions). If the helmet tends to come off your head, pull
the chin band again until the correct pressure is reached and try again.
To remove the helmet:
– Unhook the snap button by pulling the band end (see Fig. 2).
– Pull the red quick release flap until the band is loosened completely
without unthreading it from the rings (see Fig. 3).
– With the help of your thumbs, bring the pre-fastened chin band towards the
front part of the helmet so that is does not get in the way of your face and
remove the helmet.
WARNING
THE BAND MUST NEVER BE UNTHREADED FROM THE RINGS.
THE SNAP BUTTON DOES NOT HAVE THE FUNCTION OF RETAINING THE HELMET.
NEVER PULL THE RED FLAP WHILE DRIVING.
We suggest that you periodically clean the D-ring release with lukewarm water
and neutral soap.
Do not use solvents. Do not grease.
Tampering with or unforeseen events that may compromise the working order of
the retention system should not be ruled out. In this event discontinue use of
the helmet.
Fig. 1
Fig. 2
Fig. 3
305113 – 09. 2023 vers. ECE (Eletta)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>