FORTINET EVOGMT6 Stand Alone Add On Remote Start Car Starter System Installation Guide

June 17, 2024
FORTINET

FORTINET EVOGMT6 Stand Alone Add On Remote Start Car Starter System

REGULAR INSTALLATION

ADDENDUM – SUGGESTED WIRING CONFIGURATION

FORTINET EVOGMT6 Stand Alone Add On Remote Start Car Starter-System-
FIG-1FORTINET EVOGMT6
Stand Alone Add On Remote Start Car Starter-System-FIG-2

Parts required (Not included)

  • 1X 1Amp Diode
  • 1X 5 Amp Fuse
  • 1X 1k Ohm Resistor

MANDATORY INSTALL

HOOD PIN

HOOD STATUS : THE HOOD PIN SWITCH MUST BE INSTALLED IF THE VEHICLE CAN BE REMOTE-STARTED WITH THE HOOD OPEN, AND SET FUNCTION A11 TO OFF.

Notice: the installation of safety elements are mandatory. The hood pin is an essential security element and must be installed.

THIS MODULE MUST BE INSTALLED BY A QUALIFIED TECHNICIAN. A WRONG CONNECTION CAN CAUSE PERMANENT DAMAGE TO THE VEHICLE.

DESCRIPTION

FORTINET EVOGMT6 Stand Alone Add On Remote Start Car Starter-System-
FIG-5

WIRING CONNECTION

FORTINET EVOGMT6 Stand Alone Add On Remote Start Car Starter-System-
FIG-6 FORTINET EVOGMT6
Stand Alone Add On Remote Start Car Starter-System-FIG-7

KEY BYPASS PROGRAMMING PROCEDURE 1/3

CHEVROLET TRAILBLAZER

  1. Remove the battery from the OEM remote.
  2. Place the OEM remote in the front cup holder in the centre console. Refer to vehicle user guide for keyport location.FORTINET EVOGMT6 Stand Alone Add On Remote Start Car Starter-System-FIG-10 FORTINET EVOGMT6 Stand Alone Add On Remote Start Car Starter-System-FIG-11

KEY BYPASS PROGRAMMING PROCEDURE 2/3

FORTINET EVOGMT6 Stand Alone Add On Remote Start Car Starter-System-
FIG-11 FORTINET
EVOGMT6 Stand Alone Add On Remote Start Car Starter-System-
FIG-12 FORTINET
EVOGMT6 Stand Alone Add On Remote Start Car Starter-System-
FIG-13

REMOTE STARTER FUNCTIONALITY

FORTINET EVOGMT6 Stand Alone Add On Remote Start Car Starter-System-
FIG-14

  • If the vehicle is not unlocked the module will shut down the remotestarter and the vehicle as soon as any door is opened.

Notice: Updated Firmware and Installation Guides Updated firmware and installation guides are posted on our website regularly. We recommend that you update this module to the latest firmware and download the latest installation guide(s) prior to the installation of this product.

WARNING
The information on this sheet is provided on an (as is) basis with no representation or warranty of accuracy whatsoever. It is the sole responsibility of the installer to check and verify any circuit before connecting to it. Only a computer-safe logic probe or digital multimeter should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no liability or responsibility whatsoever about the accuracy or currency of the information supplied. The installation in every case is the sole responsibility of the installer performing the work and FORTIN ELECTRONIC SYSTEMS assumes no liability or responsibility whatsoever resulting from any type of installation, whether performed properly, improperly or any other way. Neither the manufacturer or distributor of this module is responsible of damages of any kind indirectly or directly caused by this module, except for the replacement of this module in case of manufacturing defects. This module must be installed by a qualified technician. The information supplied is a guide only. This instruction guide may change without notice. Visit www.fortinbypass.com to get the latest version.

TECH SUPPORT

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals