FORTINET EVO-ONE Chevrolet Trax Push to Start Remote Starters and Alarm Systems Installation Guide
- June 17, 2024
- FORTINET
Table of Contents
FORTINET EVO-ONE Chevrolet Trax Push to Start Remote Starters and Alarm
Systems
REGULAR INSTALLATION
ADDENDUM – SUGGESTED WIRING CONFIGURATION
MANDATORY INSTALL
HOOD PIN
HOOD STATUS : THE HOOD PIN SWITCH (INCLUDED) MUST BE INSTALLED IF THE VEHICLE CAN BE REMOTE-STARTED WITH THE HOOD OPEN, AND SET FUNCTION A11 TO OFF.
SECURITY STICKER
- WARNING
- Included
Notice: the installation of safety elements are mandatory. The hood pin and the sticker are essential security elements and must be installed.
THIS MODULE MUST BE INSTALLED BY A QUALIFIED TECHNICIAN. A WRONG CONNECTION CAN CAUSE PERMANENT DAMAGE TO THE VEHICLE.
DESCRIPTION
- Parts required (Not included)
- 1X 1k Ohm Resistor
WIRING CONNECTION
KEY BYPASS PROGRAMMING PROCEDURE 1/2
CHEVROLET TRAILBLAZER
- Remove the battery from the OEM remote.
- Place the OEM remote in the front cup holder in the centre console. Refer to vehicle user guide for keyport location.
REFER TO THE QUICK INSTALL GUIDE INCLUDED WITH THE MODULE FOR THE REMOTE STARTER PROGRAMMING.
REMOTE STARTER FUNCTIONALITY
If the vehicle is not unlocked with one of these conditions the remote-starter will shut down as soon as any door is opened.
Notice: Updated Firmware and Installation Guides
Updated firmware and installation guides are posted on our web site regularly.
We recommend that you update this module to the latest fi rmware and download
the latest installation guide(s) prior to the installation of this product.
WARNING
The information on this sheet is provided on an (as is) basis with no
representation or warranty of accuracy whatsoever. It is the sole
responsibility of the installer to check and verify any circuit before
connecting to it. Only a computer-safe logic probe or digital multimeter
should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no liability or
responsibility whatsoever pertaining to the accuracy or currency of the
information supplied. The installation in every case is the sole
responsibility of the installer performing the work and FORTIN ELECTRONIC
SYSTEMS assumes no liability or responsibility whatsoever resulting from any
type of installation, whether performed properly, improperly or any other way.
Neither the manufacturer or distributor of this module is responsible of
damages of any kind indirectly or directly caused by this module, except for
the replacement of this module in case of manufacturing defects. This module
must be installed by qualified technician. The information supplied is a guide
only. This instruction guide may change without notice. Visit
www.fortinbypass.com to get the latest version.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>