APOLLO CPVC Plumbing Pipes Instruction Manual
- June 9, 2024
- APOLLO
Table of Contents
APOLLO CPVC Plumbing Pipes
CPVC pipe and fittings are used in corrosive
resistant applications. CPVC resists mineral buildup and corrosion. Solvent
weld joints provide easy installation
Features
- Solvent weld installation to CPVC pipe.
- Reistant to mineral buildup and corrosion.
- CPVC systems are accepted by all major building codes.
- East installation with solvent cement.
Specifications
- 180 psi @ 73º F
- Made from chlorinated polyvinyl chloride.
- For use with CPVC pipe.
- For use with hot and cold water applications.
Approvals
- ASTM D-2846
- ANSI/NSF 61
Installation
Squarely cut CPVC pipe to desired length. Remove rough edges and sand a slight bevel around the pipe edge. Make sure the pipe fits at least 2/3 of the way into the fitting before applying the solvent cement. Apply a primer per the manufacturer’s instructions. Then, apply a heavy coat of solvent cement to the outside of the pipe. Next, apply a thin coat of solvent cement to the inside of the fitting. Make sure there are no drips. Immediately insert the pipe into the fitting. Verify the pipe goes all the way to the end of the fitting. Check the solvent cement manufacturer’s instructions on cure times. After the solvent is gone, the joint is finished and ready for testing.
The Mosack Group, Inc.
Mint Hill, NC 28227
1.888.229.2874
www.apolloflow.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>