GoGEN TWS BUDDY Wireless Stereo Headphone User Manual
- June 17, 2024
- Gogen
Table of Contents
GoGEN TWS BUDDY Wireless Stereo Headphone
SECURITY PRECAUTIONS
In order to have a proper and safe use of the headset, please read this user manual in detail and save it. Be aware of the following guidelines when using your headset:
WARNING
- You should adjust the volume carefully when using the headset to prevent hearing damage.
- Please stop using the headset in potentially hazardous situations to ensure your safety.
- Please avoid using the headset to listen to music, make or receive calls which may cause a distraction while driving.
- Put this product and its accessories somewhere out of the reach of children, to avoid a fatal danger caused by inappropriate use.
- You should keep water from entering the headset, which may cause damage to the sound quality or the headset.
- You should avoid turning the volume so high that you can’t hear anything around you. If you feel a tinnitus or the volume is too high, please reduce the volume.
- Stop using the headset if you feel obvious discomfort, irritation or have other adverse reactions.
- The headset should not be stored or used at temperatures below -10 °C or above 55 °C which may shorten headset or battery life.
TECHNICAL SPECIFICATIONS
Bluetooth Version: V 5.0
Bluetooth Profile: HSP, HFP, A2DP, AVRCP
Frequency range: 2402 MHz – 2480 MHz
Operating range: 10 m
Frequency Response: 50 Hz – 20 KHz
Rated Power: 3 mW
Sensitivity: 96 dB (±3 dB) @ 1 KHz, 126 mV
Impedance: 32 Ω ± 15%
EIRP: 3,35 dBm
Protection: IPX5
Battery: Li-Polymer 500 mAh Charging Case + 75 mAh X 2 earbuds
Music playing time: up to 8 hours + 25 hours with charging case
N.W.: 5,8 g / earbud, 70 g including charging case
Earbud Dimensions: 23 x 19 x13 mm
Charging Case Dimensions: 65 x 40 x31 mm
ACCESSORIES
Eartips, USB Charge Cable, Charging Case
DEVICE LAYOUT
- Touch control area
- Mic
- Charging interface
- Charging case battery indicator
POWER ON & PAIRING
Option 1: AUTO ON & PAIRING
With the two headsets in case and lid open to active Power ON. Take out the
headsets and wait about 10 seconds until LEFT & RIGHT earbuds AUTO paired.
Option 2: Manually ON & PAIRING
Pick up the headset from the charging case, long tap the L&R earbuds for 3-5
seconds until them powered OFF (The indicator of each earbud will flash RED
three times). After a while (5 seconds), long tap the L&R earbuds for 3-5
seconds until the indicator of each earbud flashing GREEN three times (means
Power ON),When L&R pairing is successfully done, the R earbud is working as
Master and the L is working as Slave.
BLUETOOTH CONNECTION STEPS
- Please keep your headset and mobile phone as close as you can, within 1 meter.
- Turn on “Bluetooth” in setting on your phone or other devices, and then find and select GoGEN TWS BUDDY.
- Click on GoGEN TWS BUDDY and Bluetooth Headset gets connected with your phone or devices automatically. (Some may require pass code which is “0000” (4 zeros)). The Green indicator light is flashing and the headset will prompt “Device Connected”.
TAP CONTROL INSTRUCTIONS
FUNCTION | CURRENT STATUS | ACTION |
---|---|---|
POWER ON | EARBUDS OFF | Take out from charging case or Long tap for 3 seconds |
manually
PAIRING| EARBUDS OFF| Long tap for 5 seconds manually
ACTIVATOR ON| STANDBY MODE| Long Tap 2 Sec. L Earbud to active Siri or Google
Assistant
ACTIVATOR OFF| STANDBY MODE| Long Tap 2 Sec. L Earbud to OFF Siri or Google
Assistant
ANSWER CALL| INCOMING CALL| Single tap L or R Earbud
END CALL| ON CALL| Single tap L or R Earbud
REJECT CALL| INCOMING CALL| Long tap L or R Earbud for 2 seconds
HOLD CALL| ON CALL| Long tap L or R Earbud for 2 seconds
PLAY MUSIC| CONNECTED & MUSIC ON| Single tap L or R Earbud
PAUSE MUSIC| MUSIC PLAYING| Single tap L or R Earbud
PRE. TRACK| MUSIC PLAYING| Double tap L Earbud
NEXT TRACK| MUSIC PLAYING| Double tap R Earbud
POWER OFF| EARBUDS ON| Put earbuds into charging case or Long tap for 8
seconds manually
AUTO OFF| EARBUDS ON| Disconnected over 5 minutes
CHARGING
CHARGING WAYS OF HEADSET
Put the headset(L)(R)to the corresponding position in the bottom of the charging base, close the charging base tightly. The indicator light of headset is red when being charged, and will turnoff automatically after being fully charged.
CHARGING WAYS OF CHARGING BASE
WARNING:
-
You must select a qualified charger from a regular manufacturer. (Charging Voltage: 5V Charging Current: 900mA for charging case)
-
A fully charged headset will lose its power automatically if left unused. It is recommended to charge the headset each three months.
-
Do not leave the headset in a too hot or too cold condition (best between -10°C and +40°C) which may affect the headset‘s operations although it is fully.
-
Please wear this Headset properly for best tone quality.
Do not disassemble hardware. Please use soft and dry cottons for cleaning. -
Make sure the headset is fully charged before first use.
-
This Headset is not waterproof. Do not use it while swimming or diving.
-
If do not use this Headset for long time, please charge once a week to extend battery life.
-
Keep your Headset and device as close as you can to avoid interference of signal path.
WARRANTY
Our product is warranted for 2 full year from the date of purchase. The warranty is provided on all material defects and workmanship. Guarantee of 24 months does not apply to decrease in the accumulator’s effective capacity caused by its use or age. Effective capacity gradually decreases depending on the method of use of the accumulator.
WE RESERVE THE RIGHT TO CHANGE TECHNICAL SPECIFICATIONS.
TO AVOID DANGER OF SUFFOCATION, KEEP THE PLASTIC BAG AWAY FROM BABIES AND
CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS. THIS BAG
IS NOT A TOY.
Disposal of old Electrical & Electronic Equipment (Applicable in the
European Union and other European countries with separate collection
systems)
**** This symbol on the product or on its packaging indicates that this
product shall not be treated as household waste. Instead it shall be handed
over to the applicable collection point for the recycling of electrical and
electronic equipment. By ensuring this product is disposed of correctly, you
will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling
of this product. The recycling of materials will help to conserve natural
resources. For more detailed information about recycling of this product,
please contact your local Civic Office, your household waste disposal service
or the shop where you purchased the product.
Hereby, ETA a.s. declares that the radio equipment type TWSBUDDY is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.gogen.cz/declaration_of_conformity
CUSTOMERS SUPPORT
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>