Hera DY 2BBPR-DY Dynamic Controller 24V Radio Control User Manual
- June 17, 2024
- Hera
Table of Contents
Assembly and operating Instructions
Hera Dynamic-Controller 24V Radio Control 75W
Intended use
Dynamic-Controller to connect to electronic safety isolating converter LED 24/…W with remote control; this product is for indoor use only.
- **** Disconnect from the mains supply before attempting to mount/ dismount the lighting fixture.
- Faulty parts should only be replaced with original parts.
- Always fully insert all plug connections.
- Only approved for connection to Hera LED transformers 24V with a maximum output power of 200 W.
- Hera grants no warranty when other LED converters as the prescribed converters are used.
- The total load may not exceed the nominal load of the converter.
- The specified installation distances of the converter must be maintained.
Assembly dimensions
** both LED 24 plugs must be inserted in the 12-way distributor of the
converter to the previous 12-way distributor of converter LED 24/…W
Assembly**
- Connect the LED converter to the mains.
- Connect the Dynamic-Controller to the distributor of the converter. Point 3 – 6 are only necessary to adjust further Dynamic-Controller to the same remote control:
- Push the „Study Button“ in the receiver with a sharpen object such as screwdriver or refill for a ballpoint pen. The indicator lamp turns on blue.
- Press the on/off button of the radio telecontrol for approx. 1 second. The indicator lamp flashes and turns off.
- After finish above steps, the indicator lamp is still on. It means learning is failed. Please repeat the process again.
- The Dynamic LED luminaires can now be controlled with the remote control.
Remote Control
The remote control has a remote distance of max. 15m. The Dynamic-Controller
has a memory function of the performance before a disconnection from the
mains. After reestablish the mains connection the Dynamic LED luminaires
operate in the performance before the power failure.
Installation of the Battery Multiway switching
It is possible to program up to 7 remote controls to one or more controllers.
When using the multiway switching it could be possible to press the button of
the remote control twice. This is no failure!
A combination of several Hera remote controls (mounting, recessed, 4-Channel,
Flush-mounted) is possible.
Reset-function
Press the study button three times (within 1 sec.) to delete all programmed
remote controls. Declaration of Conformity:
Hera GmbH & Co. KG declares that the product „ Hera Dynamic-Controller 24V
Radio Control“ corresponds to the directive 2014/53/EU. The full text of the
EU-Declaration of Conformity is available on the following internet address:
http://www.hera-online.de/en/technical-information/declaration-of-
conformity.html
** Do not dispose of electrical appliances in household waste, use separate
collection facilities. When replacing old appliances with new ones, the
retailer is obliged by law to accept to take back your old appliance for
disposal free of charge.
Battery safety:
– Never attempt to recharge non-rechargeable batteries.
– Insert batteries correctly, observing plus (+) and minus (-) markings.
– Battery contacts should not be short-circuited.
– Only use batteries which match the recommended battery type or correspond to
this type.
– Do not throw batteries into a fire as they could explode.
– Dispose of batteries safely.
Do not throw batteries in the household waste (!)
** Used batteries/ rechargeable batteries should not be disposed of with
normal household waste. As a consumer, you are obligated to dispose of used
batteries / rechargeable batteries at a municipal collection point or local
store, where it is free of charge. The symbol of a waste container on your
batteries / rechargeable batteries with a line through it means that the
batteries should not be disposed of with normal household waste. The symbol
below the waste container stands for Pb: Battery contains lead, Cd: Battery
contains cadmium, Hg: Battery contains mercury.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC warning:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Reproduction of this document in whole or part is forbidden.
Hera GmbH & Co. KG
Dieselstraße 9
32130 Enger / Germany
22601165401 23.10.2020
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>