Carlson 2870 DS Design Paw Extra Tall Extra Wide Freestanding Pet Gate Instruction Manual

Carlson 2870 DS Design Paw Extra Tall Extra Wide Freestanding Pet Gate Instruction Manual

READ ALL INSTRUCTIONS BEFORE ASSEMBLY AND USE OF GATE.
KEEP INSTRUCTIONS FOR FUTURE USE.

Before Assembly

PLEASE CHECK TO MAKE SURE YOU HAVE THE FOLLOWING PARTS:

A Vain Gate Panels (1)

B stabilizing Leg Assemblies (2)

C Cross head Screws (8) (requires a Phillips/cross-head screwdriver)

D Connector Bolis **(4)

**

BEFORE USING PRODUCT

Read and follow all instructions carefully to ensure that your gate is properly installed. Improper installation could result in the gate becoming unstable or dislodged from the doorway. The safety of your pet and/or child is your responsibility. Please keep these instructions for your reference.

CARE AND MAINTENANCE

Periodically check the gate for signs of damage, wear, or missing components. Do not use if any part is missing, worn or damaged. Check the gate regularly to ensure all the hardware and mountings are tightened. Do not use abrasive cleaners or bleach. Clean by sponging with warm water and a mild detergent.

90 DAYS LIMITED WARRANTY

If, during the first 90 days after consumer purchase of the item, under reasonable and non-commercial use and conditions of maintenance, it fails while owned by the original purchaser because of the quality of materials or workmanship of finish and assembly, Carlson Pet Products, Inc. will replace or repair it at Carlson’s option. PROOF OF PURCHASE REQUIRED.

Assembling and Installing Your Gate

STEP 1

Connect two halves of one stabilizing leg, then secure the leg with (4) cross head screws to secure the leg. Repeat on the other stabilizing leg.

STEP 2

Using the (4) connector bolts and a Phillips screwdriver connect the stabilizing legs to the ends of the gate.

NOTE: The connector bolts should be snug, but do not over-tighten them.

STEP 3

Extend the length of your gate to your desired size by unlocking the (4) locking hinges. Re-lock the hinges when the gate reaches your desired size.

NOTE: The locking hinges must be correctly lined up within the gap between the metal fencing. If misaligned, the lock will not fully engage. The gate may not fit an opening perfectly due to the nature of the locking increments.

STEP 4

Insert gate into the doorway with tabs on the same side as your pet will be. This will prevent your pet from pushing the gate out of the doorway.

WARNING

• INSTALL ACCORDING TO MANUFACTURES INSTRUCTIONS.
• NOT RECOMMENDED FOR USE WITH CHILDREN.
• TO PREVENT SERIOUS INJURY OR DEATH, SECURELY INSTALL GATE AND USE ACCORDING TO MANUFACTURER’S INSTRUCTIONS.
• CHILDREN HAVE DIED OR BEEN SERIOUSLY INJURED WHEN GATES ARE NOT SECURELY INSTALLED. ALWAYS INSTALL AND USE GATE AS DIRECTED USING ALL REQUIRED PARTS.
• NEVER STACK GATES ON TOP OF EACH OTHER TO FORM A TALLER BARRIER. THIS COULD RESULT IN SERIOUS INJURY OR DEATH. INTENDED FOR USE WITH CHILDREN BETWEEN 6 AND 24 MONTHS.
• STOP USING WHEN A CHILD OR PET CAN CLIMB OVER OR DISLODGE THE GATE.
• USE ONLY WITH THE LOCKING/LATCHING MECHANISM SECURELY ENGAGED.
• TO PREVENT FALLS, NEVER USE AT TOP OF STAIRS.
• NEVER USE TO KEEP CHILD OR PET AWAY FROM POOL
• ALWAYS ENSURE THE GATE IS RESTING AGAINST THE FLOOR BEFORE BEGINNING INSTALLATION.
• STRANGULATION HAZARD: PETS CAN FORCE THEMSELVES INTO VERY SMALL OPENINGS; USE THIS GATE WITH PETS WHOSE HEADS WILL NOT FIT INTO OPENINGS IN THE GATE, BETWEEN THE GATE AND FLOOR, OR BETWEEN THE GATE AND WALL. THIS PRODUCT WILL NOT NECESSARILY PREVENT ALL ACCIDENTS. NEVER LEAVE CHILD OR PET UNATTENDED. CHECK THE GATE REGULARLY TO SEE IF ALL THE HARDWARE AND MOUNTINGS ARE TIGHTENED.
• DO NOT USE IF ANY COMPONENTS ARE MISSING OR DAMAGED.
• ADULT ASSEMBLY REQUIRED.

 www.carlsonpetproducts.com
Carlson Pet Products, Inc
3200 Corporate Center Drive, Suite 105/Burnsville, MN 55306, USA /, É.-U./, EE. UU.
952.435.1084
Made in China

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>