Stromberg Carlson CC-200 Gen Secure Locking Storage Box Instruction Manual

: June 1, 2024
: Stromberg Carlson

Table of Contents

Dimensions
Specifications
Warnings
Installation Instructions
Customer Support
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Stromberg Carlson CC-200 Gen Secure Locking Storage Box

Stromberg Carlson CC-200 Gen Secure Locking Storage Box

Dimensions

Specifications

Fits on Trailer Trays (CC-255)
Adapter kits for A frame and 4” square bumper available January 2024
Aluminum diamond plate won’t rust
Maximum generator dimensions: 29” wide, 21” tall, 14-3/8” deep

Warnings

Gen Secure (CC-200) is designed to discourage theft of stored items under lock and key. All safes can be cracked, so please be aware we can slow a thief down, but cannot prevent the most motivated burglar. In short, we are not responsible for stolen items from our locked box.

Vents are provided in our generator box to allow residual propane fumes and gas fumes to exhaust while parked or traveling.

When operating your generator the CC-200 lid must remain open to properly create enough airflow to cool your generator. Lid must remain open until generator is cool to the touch.

There is a lock knob to help you secure the lid in your desired position. The lid is limited to opening just past 180 degrees to protect your vehicle’s siding.

Rubber access ports can be scored and used to:

Allow access to cords and plugs.
Allow direct venting of exhaust fumes and residue via a tube if you wish to hook one up.

Tie down rings have been welded into our box to secure any materials stored – including a generator – with our provided tie down straps.

Symbol
This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

Patent Pending INS-CC200-C 11.16.2023

Installation Instructions

Put the CC-200 Generator Box / Storage Box on the CC-255 Trailer Tray.
Install the bolts (A) through the Trailer Tray in the storage box bottom holes with nut inside box, put the fender washers (C) on the nuts, then tighten the screws (B).