Carlson 0932 PW DS 51 Extra Wide Walk Thru Pet Gate with Lift Handle Instructions

Carlson 0932 PW DS 51 Extra Wide Walk Thru Pet Gate with Lift Handle

Extra Wide Walk-Through Gate with Small Pet Door

READ ALL INSTRUCTIONS BEFORE ASSEMBLY AND USE OF GATE. ? KEEP INSTRUCTIONS FOR FUTURE USE.

• www.carlsonpetproducts.com

• Carlson Pet Products, Inc.
  3200 Corporate Center Drive, Suite 105 / Burnsville, MN 55306, USA/, E.-U. /, EE. UU. e

• 952.43s.1 os4

• Made in China/Fabrique en Chine/Hecha en China

Before Assembly

PLEASE CHECK TO MAKE SURE YOU HAVE THE FOLLOWING PARTS:

• A 12″ Extension (1)
• B Gate Door Panel (1)
• C 6″ Extension (1)
• D Wa11Cups(4)
• E 1″Wa11MountScrews(4)
• F Threaded Spindle Rods (4)

BEFORE USING PRODUCT

Read and follow all instructions carefully to ensure that your gate and extensions are properly installed. Improper installation could result in the gate becoming unstable or dislodged from the doorway. Always make sure the extension is securely attached to the gate before using. The safety of your pet and/or child is your responsibility. Please keep these instructions for your reference.

IMPORTANT

• Never use more than two extensions per side of gate.
• If hardware mounting to a surface other than drywall or wood, please consult with a professional about installation.

REMOVING YOUR GATE FROM THE WALL
To remove your gate from the wall, rotate the adjustment wheels on each of the (4) threaded spindle rods to depressurize the gate from its doorway or opening. Then, gently pull or push the gate free from its doorway or opening.

CARE AND MAINTENANCE

Periodically check the gate for signs of damage, wear, or missing components. Do not use if any part is missing, worn or damaged. Check the gate regularly to ensure all the hardware and mountings are tightened. Do not use abrasive cleaners or bleach. Clean by sponging with warm water and a mild detergent.

90 DAYS LIMITED WARRANTY

If, during the first 90 days after consumer purchase of the item, under reasonable and non-commercial use and conditions of maintenance, it fails while owned by the original purchaser because of the quality of materials or workmanship of finish and assembly, Carlson Pet Products, Inc. will replace or repair it at Carlson’s option. PROOF OF PURCHASE REQUIRED.

Assembling and Installing Your Gate

• Locate the (41 threaded spindle rods (Fl Rotate the adjustment wheels along the threading, eliminating the gap between the adjustment wheel and the rubber foot.
  NOTE: You will notice a slight gap between the gate door latch and the frame. This is not a defect. Your gate is a pressure mounted gate and this gap will disappear once you tighten your gate in its opening.

• Insert the (41 threaded spindle rods into the holes at each of the four corners of the gate.
  NOTE: It may be necessary to hold the threaded spindle rods or rubber feet while rotating the adjustment wheels to ensure the entire unit does not rotate.

Operating the Door Latch

• Pull the spring lock away from the secure lift latch while simultaneously lifting the loci lever upwards. This will release the locking latch from the gate frame and allow the door to push or pull open. To lock the door shut, close the door completely, then push down on the lock lever to re-engage the spring lock
  NOTE: If your secure lift latch is not properly engaging with the receiving component, ensure that your gate is level, mounted properly, and that you have not over-tightened the threaded spindle rods.

• At the bottom of the gate door, rotate the base lock to the horizontal position to allow the door to swing open.
  NOTE: Place lock down on side occupied by the child.

Positioning and Attaching Wall Cups

• After you have mounted your gate, and you are satisfied with its positioning, draw a circle on the suriace of your doorway or opening around the perimeter of the (4) rubberfeet.
  Next, completely remove the gate from the opening by loosening each of the (4) threaded spindle rods to depressurize the gate.

• With the gate fully removed, you can now use the circles you marked during Step 1 as guides for screwing in your (4) wall cups(D). Center each of the wall cups within the guide circles and use the provided self-tapping 25mm screws (E) to fasten them in place via the hole through the center of each wall cup.

• Reinstall your gate in the doorway or opening according to the instructions, using the newly installed wall cups as anchoring points for the (4) threaded spindle rods.

Adding a Gate Extension

Remove the top and bottom threaded spindle rods.
Assemble the gate and extension as illustrated. Reposition the gate and lit in accordance with the gate fitting.

NOTE: It is preferable to install any extensions on the hinge side of the gate.

Need more width? Additional extensions sold separately
www.caitsonpetproducts.com

WARNING

NOTE: The gap between the gate and wall should not exceed more than 2.5 inches.

• INSTALL ACCORDING TO MANUFACTURES INSTRUCTIONS.

• NOT RECOMMENDED FOR USE WITH CHILDREN.

• TO PREVENT SERIOUS INJURY OR DEATH, SECURELY INSTALL THE GATE AND USE IT ACCORDING TO THE MANUFACTURER’S INSTRUCTIONS.

• CHILDREN HAVE DIED OR BEEN SERIOUSLY INJURED WHEN GATES ARE NOT SECURELY INSTALLED.
  ALWAYS INSTALL AND USE GATE AS DIRECTED USING ALL REQUIRED PARTS.

• YOU MUST INSTALL WALL CUPS TO KEEP GATE IN PLACE. WITHOUT WALL CUPS, CHILD CAN PUSH OUT AND ESCAPE.

• NEVER STACK GATES ON TOP OF EACH OTHER TO FORM A TALLER BARRIER. THIS COULD RESULT IN SERIOUS INJURY OR DEATH.

• INTENDED FOR USE WITH CHILDREN BETWEEN 6AND 24 MONTHS.

• STOP USING WHEN A CHILD OR PET CAN CLIMB OVER OR DISLODGE THE GATE.

• USE ONLY WITH THE LOCKING/LATCHING MECHANISM SECURELY ENGAGED.

• TO PREVENT FALLS, NEVER USE AT TOP OF STAIRS.

• NEVER USE TO KEEP CHILD OR PET AWAY FROM POOL.

• ALWAYS ENSURE THE GATE IS RESTING AGAINST THE FLOOR BEFORE BEGINNING INSTALLATION.

• THIS IS A PET GATE, BUT WHEN USED WITH CHILDREN, THE SMALL PET DOOR MUST REMAIN CLOSED AND SECURELY LATCHED.

• STRANGULATION HAZARD: PETS CAN FORCE THEMSELVES INTO VERY SMALL OPENINGS; USE THIS GATE WITH PETS WHOSE HEADS WILL NOT FIT INTO OPENINGS IN THE GATE, BETWEEN THE GATE AND FLOOR, OR BETWEEN THE GATE AND WALL.

• THIS PRODUCT WILL NOT NECESSARILY PREVENT ALL ACCIDENTS. NEVER LEAVE CHILD OR PET UNATTENDED.

• CHECK THE GATE REGULARLYTO SEE IF ALL THE HARDWARE AND MOUNTINGS ARE TIGHTENED.

• DO NOT USE IF ANY COMPONENTS ARE MISSING OR DAMAGED.

• ADULT ASSEMBLY REQUIRED.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>