ATOMSTACK F03-0191-0AA1 Z-Axis Height Adjuster Installation Guide

June 17, 2024
ATOMSTACK

Z-Axis Height Adjuster

Installation Manual


F03-0191-0AA1 V01

Note: The picture is for reference only, the actual product shall prevail
For more information, please scan the QR code.

Accessories List

Z-Axis Height Adjuster Module*1pcs

M4X812PCS             M4X64PCS

H2.5

M4X10*4PCS                           H3

M5X86PCS         Fixed Focus Piece1PCS

Type1    If your laser is in the form shown in the figure below, please

follow these steps to install the Z-axis height adjustment module.

Type 1

(1) Remove the original laser backplate and laser

2-1                           2-2
(2) Rotate the handle to align hole positions 2-1 and 2-2 in the figure above

(3) Fix laser and Z-axis height adjuster, M5*8/2pcs

(4) Assemble the combined Z-axis height adjuster and machine, M4*8/4pcs

Two Fixed Focus Modes

Fixed focus height 2.5mm          Fixed focus height 10mm

Precautions

(1) In order to ensure that the machine does not shake during operation and is more stable, the Z-axis height adjuster restricts the laser from working as close to the height of the POM wheel as possible. So when using, the engraved surface needs to be raised to a suitable position.

(2) The Y-axis engraving format has been reduced by 20mm due to the addition of the Z-axis height adjuster. If a limit switch is required, the user needs to move it forward by 20mm.

Type 2    If your laser is in the form shown in the figure below, please

follow these steps to install the Z-axis height adjustment module.

Type 2

(1) Remove the laser slide rail and laser

2-1                        2-2
(2) Rotate the handle to align the hole positions 2-1 and 2-2 in the figure above

(3) Assemble laser slider and Z-axis height adjuster, M5*8 screw

4-1                   4-2
(4) Adjust the handle to align the hole positions 4-1 and 4-2, M5*8 screw

(5) Fix Z-axis height adjuster and machine, M4*10 screws

(6) Assemble the laser

Type 3    If your laser is 20W or 30W, please follow these steps to

install the Z-axis height adjustment module.

Type 3

(1) Remove the laser and slide rail

(2) Assemble Z-axis height adjuster and machine, M4*6

(3) Install laser slider, M4*8/4pcs

(4) Assemble the laser

Precautions

(1) In order to ensure that the machine does not shake during operation and is more stable, the Z-axis height adjuster restricts the laser from working as close to the height of the POM wheel as possible. So when using, the engraved surface needs to be raised to a suitable position.

(2) The Y-axis engraving format has been reduced by 20mm due to the addition of the Z-axis height adjuster. If a limit switch is required, the user needs to move it forward by 20mm.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

ATOMSTACK User Manuals

Related Manuals