CHAMPION POWER EQUIPMENT 201176 Tri Fuel Open Frame Inverter Generator User Guide

CHAMPION POWER EQUIPMENT 201176 Tri Fuel Open Frame Inverter Generator

PARTS INCLUDED

SAFETY INFORMATION

DANGER

MOVE GENERATOR OUTDOORS

Using a generator indoors CAN KILL YOU IN MINUTES. Generator exhaust contains carbon monoxide. This is a poison you cannot see or smell.

NEVER use inside a home or garage, EVEN IF doors and windows are open. ONLY use OUTSIDE and far away from windows, doors, and vents.

WARNING

Read the ENTIRE operator’s manual to become familiar with the features of this product before operation. This QuickStart Guide IS NOT a substitute for the Operator’s Manual.

NOTICE

Keep all objects at least 5 feet (1.5 m) from generator. Heat from the muffler and exhaust gas can ignite combustible materials.

SET UP

Remove Hardware. Assembly > Remove Shipping Support Hardware

Attach wheel kit. Assembly > Install Wheel Kit

Connect the battery. Assembly > Connect the Battery.

Cut cable tie on each side of battery connector.  Push two halves of battery connector together tightly.

Add oil.   Assembly > Add Engine Oil.

Recommended: 10W-30, up to 37.2 fl. oz. (1100 ml) DO NOT overfill.

Move the generator outdoors.

ONLY USE OUTSIDE AND FAR AWAY FROM WINDOWS, DOORS, AND VENTS.

START UP

Add fuel – Gasoline, Propane (LPG), or Natural Gas (NG)

Assembly > Add Fuel

DO NOT plug in any electrical devices.

NEVER START OR STOP THE GENERATOR WITH ELECTRICAL DEVICES CONNECTED OR TURNED ON!

Starting the Engine: Gasoline

Electric Start

1. Turn fuel select dial to “GASOLINE OPERATION” position.
2. Move the choke lever to the “CHOKE” position.
3. Press and hold the ignition switch to the “START” position.
4. Move the choke lever to the “RUN” position.
   

Manual Start

1. Turn fuel select dial to “GASOLINE OPERATION” position.
2. Move the choke lever to the “CHOKE” position.
3. Pull the starter cord.
4. Move the choke lever to the “RUN” position.
   

Starting the Engine: Propane (LPG) and Natural Gas

Electric Start

1. Open the propane tank or natural gas valve.
2. Turn fuel select dial to “PROPANE OPERATION” or “NATURAL GAS OPERATION” position.
3. Move the choke lever to the “CHOKE” position.
4. Press the ignition switch to the “START” position for 2-3 seconds.
5. Move the choke lever to the “RUN” position.
6. Press and hold the ignition switch to the “START” position.
7. If engine does not start, wait 10 seconds, then repeat step 6.
   

Manual Start

1. Open the propane tank or natural gas valve.
2. Turn fuel select dial to “PROPANE OPERATION” or “NATURAL GAS OPERATION” position.
3. Move the choke lever to the “CHOKE” position.
4. Pull the starter cord 2-3 times until you feel some combustion pulses.
5. Move the choke lever to the “RUN” position.
6. Pull the starter cord.
   

Plug in. Operation > Connecting Electrical Loads

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>