Champion Power Equipment CPEKEY01 Remote Controller User Manual
- June 6, 2024
- CHAMPION POWER EQUIPMENT
Table of Contents
Champion Power Equipment CPEKEY01 Remote Controller
IC Caution
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device
FCC Caution
Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Information to user
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Information to the user
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Descriptions
CPEKEY01 is an electronic key for engine wireless remote control. It’s a learning remote controller and based on 433MHZ center frequency. Its theoretical remote distance can reach approximately 80 m in the open air.
Specifications
- Work Voltage:DC 6V
- Work Freqency:433MHZ
- Work Range: <80m, depending on surroundings and corresponding receiver. Working Temperature: -15 ~ 50℃
- Storage Temperature: -40 ~ 70℃
- Relative humidity: Max. 95 %
Operation
- Key 1# “START” transmits a remote signal to the receiver to control the engine start.
- Key 2# “STOP” transmits a remote signal to the receiver to control the engine stop.
- The two green LEDs will be lightened when Key1# or Key2# is pressed.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>