MICSIU 700214 Clear Glass Outdoor Wall Lantern Instruction Manual
- June 17, 2024
- MICSIU
Table of Contents
MICSIU 700214 Clear Glass Outdoor Wall Lantern Instruction Manual
IMPORTANT SAFETY INSTRUCTIONS
- Warning: If any special control devices are used with this fixture, follow the instructions carefully to assure full compliance with N.E.C. requirements. If there are any questions, contact a qualified electric contractor.
- Warning: This product can expose you to chemicals including lead, which is known to the State of California, to cause cancer or birth defects or other reproductive harm. For more information, please go to www.P65Warnings.ca.gov
- Caution: Electrician installation highly recommended. All glass is fragile, use care when handling glass component(s) and or lamp(s). Read instructions carefully and turn electricity off at the main circuit breaker panel before beginning installation.
Important Notice:
This is a generic instruction sheet used for various fixtures.
The shape and style of fixture / glass / shade / diffuser may vary.
(Required Supply Circuit: 120V, 60Hz. Bulb Type: 1E26100W Max)
Compatible Bulb Type (NOT Included)
The mostly suggested bulb type is 11W LED A19
COMPONENTS INCLUDED IN THE PACKAGE
Fixture with hard wares
Parts included in yellow parts bag Parts X 2 for 2 pack item.
ASSEMBLY & INSTALLATION STEPS
- Open the box from top, take out all the components, parts bag and manual from the box carefully.
- Check all the components against the parts list. Make sure get each parts on list. If any parts missing and glass damage, please contact manufacturer at: support@micsiu.com to get a replacement. Parts are NOT included for which is shown as 0 under ****QTY.
| Part Name | QTY | Code |
|---|---|---|
| Junction Box | 0 | A |
| Leading Wire | 2 | B |
| Mounting Bracket | 1 | C |
| Mounting Screw (1.25″) | 2 | D |
| Washer | 2 | E |
| Screw | 2 | F |
| Back Plate | 1 | G |
| Wire Nut | 3 | H |
| Wire | 2 | H |
| Socket | 1 | I |
| Fixture Frame | 1 | J |
| Glass | 4 | K |
| Glass Clip | 8 | L |
| Bulb | 0 | N |
- Refer to the illustration while doing assembly and follow the steps as below:
- Screw the bulb (N) onto the socket (J) before installation.
- Assemble the mounting bracket (C) to the junction box (A) with two mounting screws (D) . Adjust the mounting bracket to a horizontal position.
- Connect the wires according to the wiring diagram below.
- Attach the back plate (G) to the mounting bracket (C), align the holes, and fix with washers (E) and screws (F).
All glasses are fixed before shipping. In case of glass damage, unlock the glass clips (M) on the bottom of frame (K) to release the damaged glass (L), then carefully replace with a new one and bend the glass clip (M) to secure the glass (L) in position.
Illustration of assembly and wiring:
Missing parts? Glass damage? Any questions?
Please email us at: support@micsiu.comWe are
always here to help you fix the problems you are facing.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>