MICSIU 700207 2 Light Outdoor Entrance Wall Sconce Instruction Manual
- June 17, 2024
- MICSIU
Table of Contents
700207 2 Light Outdoor Entrance Wall Sconce
Instruction Manual
Missing parts? Glass damage? Any questions?
Please email us at: support@micsiu.com
We are always here to help you fix the problems you are facing.
Assembly & Installation Instructions
MODEL: 700207 700208
IMPORTANT SAFETY INSTRUCTIONS:
- Warning: If any special control devices are used with this fixture, follow the instructions carefully to assure full compliance with N.E.C. requirements. If there are any questions, contact a qualified electric contractor.
- Warning: This product can expose you to chemicals including lead, which is known to the State ofCalifornia, to cause cancer or birth defects or other reproductive harm. For more information,please go to www.P65Warnings.ca.gov
- Caution: Electrician installation highly recommended. All glass is fragile, use care when handlingglass component(s) and or lamp(s). Read instructions carefully and turn electricity off at the maincircuit breaker panel before beginning installation.
Important Notice:
This is a generic instruction sheet used for various fixtures.
The shape and style of fixture / glass / shade / diffuser may vary.
(Required Supply Circuit: 120V, 60Hz. Bulb Type: 1E26100W Max)
COMPONENTS INCLUDED IN THE PACKAGE
Fixture with hardwares| Parts included in yellow parts bag.
Parts X 2 for 2 pack item
---|---
|
ASSEMBLY & INSTALLATION STEPS:
- Open the box from top, take out all the components, parts bag and manual from the box carefully.
- Check all the components against the parts list. Make sure get each parts on list. If any parts missingand glass damage, please contact manufacturer at: support@micsiu.com to get a replacement.
Parts are NOT included for which is shown as 0 under QTY.
PARTS LIST (Parts QTY X 2 for 2 pack item)
Part Name| QTY| Code| | Part Name| QTY| Code
Junction Box| 0| A| Wire Nut| 3|
Leading Wire| 2| B| Wire| 2| J
Universal Mounting Bracket| 1| C| Socket| 1| K
(1.25″) Mounting Screw| 2| D| Fixture Frame| 1| L
Stud| 2| E| Glass| 4| M
Backplate| 1| F| Glass Clip| 8| N
Washer| 2| G| Bulb| 0| 0
Cap Nut| 2| H| | |
3. Refer to the illustration while doing assembly and follow the steps as below:
I Screw the bulb (O) onto the socket (K) before installation.
II Thread two studs (E) onto the mounting bracket (C) at proper position.
III Attach the mounting bracket (C) to the junction box (A) by two
mounting screws (D). Adjust the mounting bracket to a horizental level.
IV Connect wires according to the wiring diagram as below.
V Attach the backplate (F) to two studs (E) and fix with two washers (G)
and cap nuts (H).All glasses are fixed before shipping. In case of glass
damage, unlock the clips (N) on the bottom of fixture frame (L) to release the
damaged glass (M), then carefully replace with a new glassand bend the clips
(N) back to position to fix the glass (M) onto the fixture frame (L).
