GLOBAL INDUSTRIAL 27951 3 Tier Wood Locker Instruction Manual
- June 17, 2024
- GLOBAL INDUSTRIAL
Table of Contents
GLOBAL INDUSTRIAL 27951 3 Tier Wood Locker
Maintenance Tips
*To clean remove or stains, use a piece of flannel dampened with a water and alcohol solution. Avoid direct sunlight.
HARDWARE LIST
The hardware drawings are full-scale, so their dimensions are the same as the actual hardware
KIT TO AVOID TIPPING (Quantity per module)
NOTE: OPTIONAL BUILT-IN LOCKS AVAILABLE UPON REQUEST
IN THE PURCHASE. SEE RELATED ITEMS BELOW.
P| MODEL 01 – KIT BUILT-IN LOCKERS (Lift up hasp locker Kit)
| 03
---|---|---
Q| MODEL 02 – KIT BUILT-IN LOCKERS (Electronic locker Kit)
| 03
- Make sure that the area where the cabinets and their bases will be installed is plumb and level.
- Check the ventilation spacing between the back of the cabinets and ensure that the side panels have been properly installed. Align the cabinets to secure them to the wall. The side panels must fully touch the wall.
- Fold the metal plate and install it on top of the cabinets as shown below.
KIT TO AVOID TIPPING
Back-to-back cabinet installation
-
Make sure that the area where the cabinets and their bases will be installed is plumb and level.
-
Check the ventilation spacing between the back of the cabinets and ensure that the side panels have
been properly installed. Align the cabinets to secure them back-to-back. The side panels must fully touch
each other. -
Install the metal plates on top of the cabinets as shown below.
| ID | Description | # Of Pieces | Dimension (mm) |
|---|---|---|---|
| 01 | Left side | 01 | 1828x350x15 |
| 02 | Right side | 01 | 1828x350x15 |
| 03 | Large shelf | 04 | 274x350x18 |
| 04 | Small shelf | 03 | 274x127x18 |
| 05 | Back | 01 | 1826x300x6 |
| 06 | Door | 03 | 596x293x18 |
Side panel installation (add-on sold separately)
- Make sure that the area where the cabinets and their bases will be installed is plumb and level.
- Position the side panels so that they’re aligned with the front of the cabinet body (not the door) Check-01. The spacing created between the end of the panel and the back of the cabinet is for ventilation Check-02.
- After they are positioned use the hardware that comes with the side panel to join them through the existing holes inside the cabinet wall as shown below.
Corporate assembly
Join cabinets
- Start by positioning the cabinets side by side, ensuring they are plumb and level.
- After they are positioned, use hardware (H) to join them through the existing holes inside the cabinet wall, as shown below.
Metal base installation (add-on sold separately)
- Make sure that area where the cabinets and their bases will be installed is plumb and level.
- Position the metal base, aligning and centering it on the body of the previously joined cabinets.
- After they are positioned, use the hardware that comes with the metal base component to join the parts on to the metal base to the cabinet base, as shown below.
Three-dimensional door hinge adjustment: follow the instructions below
Upward and downward height adjustment
Sideways adjustment
Backward and forward depth adjustment
Fastening latch
Note: latch is part of the lock
Install the latch
Install the security screw
Sideways adjustment
OPTIONAL BUILT-IN LOCKS
MODEL 02 – KIT BUILT-IN LOCKERS (Electronic locker Kit)
Fastening latch
Note: latch is part of the lock
Install the latch
Sideways adjustment
Install the security screw
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>