MEFERI ME10 Wearable Computer User Guide

User Guide
V1.0.Oct 2023
ME10
Wearable Computer
Quick Start Guide

Overview

Package Contents

• Device x1
• USB Cable x1
• Quick Start Guide x1
• Battery x1
• Wrist Mount x1
• Power Adapter x1

Instructions for Unpacking

Micro SD card installation
Slide the rear cover lock of the device upwards to the open state, open the rear cover, slide the silver SD card cover in the “open’” direction, then lift the card cover to put in the SD card. and finally slide the card cover in the “lock” direction to fix it. Battery Installation
Insert the right half of the battery obliquely into the battery compartment with the battery label facing upward and the NFC facing outward, and press the upper left corner of the battery to fully insert the battery.

Battery removal
Slide the silver battery lock next to the battery to the left to the open position, and press the finger on the left side of the battery to take out the battery upwards.

Instructions for Charging

Connect the USB-A port to the adapter, and the other end to the device.

Power Options

• Power on: Press and hold the power button until you see a splash on the device.
• Power off: Press and hold the power button until a pop-up window appears and then click “Power off’.
• Restart: Press and hold the power button until a pop-up window appears and then click “Restart”.

Indicator Battery

Battery

| Full power
---|---
Medium power
Low power
WiFi| WiFi connected
NONE WiFi switched off

Wrist mount installation (as shown in the figure below) Note: The two knobs should be aligned with the red direction.

The lanyard of the wrist strap must be installed on the four corners of A. B.C. D of the base.

Install equipment

Press the red button to disassemble the device.

Adjust the wrist mount

1. Press the two knobs. turn clockwise to the left. and shrink the wrist strap.
2. Pull up in two knobs. then pull the strap sideways to lengthen the strap.

Precautions

1. Read all information in this guide before using the device to ensure safe and proper operation.
2. Please use the accessories that have been approved by MEFERI and corresponds to this model. Use of any power source. charger. battery. etc. that has not been approved by MEFERI may cause a fire, explosion, or other hazards.
3. Please use device and accessories within the specified temperature range. Equipment failure may occur when the ambient temperature is toa high or too low.
4. If the battery is not detachable. please do not replace the battery by yourself in case of any damage to the battery or the device. The battery shall be replaced by authorized service centers only.
5. Do not disassemble the product and its accessories. If the equipment or any of its components are not working properly. please contact and consult our after-sales service center. or send the device to our after-sales service outlets for testing and servicing.
6. If the battery shows abnormal signs of peculiar smetl, overheat. color change. distortion or leakage, remove the battery from the charger or the device immediately and stop using it.
7. The battery is made from a flammable and explosive material. Donot disassemble, squeeze, drop and make any other destructive operations on the battery. Do not place the battery in high temperature.
8. Disposal of used batteries is subject to local relevant documents or policies regarding disposal of used batteries.

Warranty Policy

Warranty terms:

1. Under normal circumstances. the warranty period of the device is 12 months. 3 months for accessories. subject to the sales agreement.

2. Ouring the product warranty period, under the normal use conditions (determined by our technical staff), the user will be entitled to a free warranty for damaged or faulty warranty parts.

3. During the warranty period. faults caused by repair. disassembly or Modification of the product by a personnel other than our company. improper installation, improper use by the user (failure to follow instructions), serial number damage. accident or natural disaster, will not be covered under the warranty.

4. The warranty will expire immediately if any alterations are made to the warranty card.

5. Please show the equipment SN and purchase certificate for repair.
   The company reserves the right to interpret the above contents.

6. If you have trouble using the device. please e-mail to meferi@meferi.com.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harm full interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Specific Absorption Rate (SAR) information:
This Device meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure Information and Statement the SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: Device has also been tested against this SAR limit. This device was tested for typical body-worn operations with the back of the device kept Omm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain an Omm separation distance between the user’s body and the back of the device. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>