HARVARD TEMP Glaze LC Dental Instruction Manual
- June 17, 2024
- HARVARD
Table of Contents
Instructions for Use
Harvard TEMP Glaze LC
Light cure one component varnish for temporary crowns and bridges
Harvard TEMP Glaze LC is a light cure one component acrylic varnish which
cures hard without any smear layer. Chemically it is based on multifunctional
acrylates.
Its preferred use is sealing and improving the surfaces of temporary crowns or
bridges based on acrylic system.
Properties
The special properties of Harvard TEMP Glaze LC are its full dry surface
without leaving a smear layer after light polymerisation, its hard high gloss
surface and its more abrasion resistant surface.
The resistance of the covered device will even be improved against solvation
by some denture cleaning agents and against deposition of food rests and
plaque, which is advantageous for patient.
Indications
Harvard TEMP Glaze LC is for sealing the surface of
– temporary crowns and bridges based on acrylics
– complete and partial dentures
Contraindications/side effects
Do not use in case of known allergy against the components. Varnish contains
methylmethacrylate!
Incompatibility with other materials
Do not use in combination with substances containing eugenol.
Application
a) After creating the acrylic crown wash off the smear layer with a suitable
solvent e.g. alcohol.
b) Apply a thin layer of Harvard TEMP Glaze LC without inclusion of air
bubbles with a brush or with a foam onto the dull surface.
c) Place into a light oven suitable for curing light cure composit inlays,
onlays, veneers etc, or light cure trays.
d) The curing time depends on efficiency of the light cure unit:
Stroboscopic light Dentacolor XS (Heraeus Kulzer) will take about 1½ minutes,
weaker lights up to 3 minutes.
Dental-Halogen Light Cure Unit (min. 500 mW/cm²) or LED Curing Light (min.
1000 mW/cm²): minimum 20 seconds each side.
e) after light curing slight or no polishing is indicated.
The surface shines high gloss.
Note
Close bottle immediately after use.
Do not apply or cure Harvard TEMP Glaze LC in the mouth!
Warnings
Harvard TEMP Glaze LC contains Methylmethacrylate.
Do not use in case of known allergy against methyl methacrylate.
Storage information
Storage temperature 4-25°C (39-77°F). Protect from direct sunlight. Do not use
after expiry date.
Warranty
Harvard Dental International GmbH warrants this product will be free from
defects in material and manufacture. Harvard Dental International makes no
other warranties including any implied warranty of merchantability or fitness
for a particular purpose. User is responsible for determining the suitability
of the product for user’s application. If this product is defective within the
warranty period, your exclusively remedy and Harvard Dental Internationals
sole obligation shall be repair or replacement of the Harvard Dental
International product.
Limitation of Liability
Except where prohibited by law, Harvard Dental
International GmbH will not be liable for any loss or damage arising from this
product, whether direct, indirect, special, incidental or consequential,
regardless of the theory asserted, including warranty, contract, negligence or
strict liability.
Only for dental use!
Store product out of reach of children!
The instructions for use has to be kept for the duration of the application.
Order-No. Article
Harvard TEMP Glaze LC
7081730 30 ml bottle
Harvard Dental International GmbHMargaretenstr. 2 – 4
15366 Hoppegarten, Germany
0482
Made in Germany
Tel: +49 (0) 30/99 28 978-0
Fax: +49 (0) 30/99 28 978-19
info@harvard-dental-international.de
www.harvard-dental.de
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>