BOYO VTB44M 4.3 Inch Rearview Mirror Monitor User Manual
- June 17, 2024
- BOYO
Table of Contents
BOYO VTB44M 4.3 Inch Rearview Mirror Monitor
SPECIFICATIONS
- Monitor : Digital TFT LCD screen
- Video input :: Two ways video
- Dual Mounting Solution : CIip-on and Replace the Mounting bracket
Installation Instruction
KEYS OPERATION INSTRUCTION
- (I) Power on/off key. Press” “to choose power on or power off.
TO USER
- Dear User, Thank you for choosing and using our Rearview Mirror Monitor. We are going to provide the best products and the best services to you. To insure the best performance and function, please kindly read this manual carefully and install it accordingly.
- We reserve all rights for our Rearview Mirror Monitor, including the designs and the software.Any unauthorized copy or translation is prohibited And the specification and information of the products related in the Manual provide the references only„and the content of the Manual will be renewed according to the progress of the products without advance information, and the final explanation rights of the Manual is reserved by us
PARTS
-
(2 ) “M” menu/Proceed key. Press “M” for the main Menu to choose the functions setting. You may able to set up ratio, language, reset, exit and etc. through the Main Menu. In the main Menu interface, Press ” ” to UP /down, then press “M” to enter the submenu. In the main Menu interface, Press ” to “EXIT” then press “M” and choose the main Menu interface. It will automatically exit the “Main Menu” within IOsec if no operation.
-
(3) “VI/V2 “two video input key.
Press the “VI /V2″key to choose VI or V2. It will show “VI “or “V2” on the top right corner of the Monitor.lf no video signal , it will show “NO SIGNAL VI” or ” NO SIGNAL V2″ . It will automatically turn off within 8sec if no signal. -
Notes : These are two systems you can choose in Monitor, the “Manual” and “Automatic” systems. “Manual” means when the vehicle starts, you are pressing the” (5 ” button to turn on the monitor. “Automatic” means, that when the vehicle starts,the monitor will turn on automatically. The factory’s original setting is “Manual”.
if you’ ‘d like the monitor to turn on automatically, press” ” ” at the same time, then the Monitor will show “Automatic” and the setting will change to “Automatic”, If it’s set to “Manual” again, do the same as “Automatic” Make sure to keep your “Manual” mode setting on VI while the monitor is not in back-up mode. -
**Green trigger wire should connect to the backup light (1 2V).
-
Notes : if VI connects the front camera, pls choose “Manual”state.