BRYDGE 12.9 Wireless Keyboard User Manual
- June 17, 2024
- Brydge
Table of Contents
BRYDGE 12.9 Wireless Keyboard
Specifications
- Designed For: iPad Pro 12.9
Insert/Remove
Lift your iPad to test the hinge grip. Your iPad and Brydge should be held firmly together. If the iPad is loose, remove and give the hinges a gentle squeeze. Repeat this process until your iPad is held firmly. To remove, hold your iPad and pull straight up, with one hand firmly holding your Brydge against a hard surface.
USER MANUAL
Thank you for purchasing your Brydge 12.9!
Additional informational videos and instructions available at https://www.brydgekeyboards.com/pages/product-instruction-manuals
INSERT/REMOVE
- Place your Brydge on a flat surface, rotate the hinges upright to 90º and insert your iPad into the hinges with the home button on the right
- Lift your iPad to test the hinge grip. Your iPad and Brydge should be held firmly together
- If the iPad is loose, remove and give the hinges a gentle squeeze. Repeat this process until your iPad is held firmly
- To remove, hold your iPad and pull straight up, with one hand firmly holding your Brydge against a hard surface
POWER
- To manually power on, press and hold the power key; the light will turn green for 3 seconds to indicate power
- NOTE: Once paired, your Brydge will automatically wake upon opening. The power key will turn green for three seconds to let you know your Brydge is awake
- To manually power off, press and hold the power key for 3 seconds; the light will turn red momentarily to indicate it’s powered off
- NOTE: To conserve battery, your Brydge will enter sleep mode after 20 minutes of non-use. Press any key to turn back on. Your Brydge will enter sleep mode when both devices are closed like a laptop
PAIR
- Once the keyboard is on, press and hold the BluetoothTM key for 3 seconds. The power key will flash blue until the keyboard is successfully paired
- On your iPad, under Settings > Bluetooth select Brydge 12.9
The light on the power key will shut off to let you know the Brydge has paired and the iPad Settings will say connected
CHARGE
- To check battery life, press and hold the battery key for four seconds Power key will flash three times:
- Green = 75-100%
- Yellow = 25-74%
- Red = 10-24%
- When battery is 9% or lower, backlit keys will be disabled and light will flash continuously.
- To charge your Brydge insert the supplied MICRO USB cable into the charging port on the front right corner
NOTE : Charging can take up to 3 hours
The battery is charging when the light on the power key is red; your Brydge is fully charged when the light turns off*
Once done charging unplug the cable and Go Do More. The battery should last up to 12 months depeding on use.
- Have a question? Contact Brydge directly atsupport@brydgekeyboards.com
- Find more information and instructional videos athttps://www.brydgekeyboards.com/pages/product-instruction-manualsThis device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the recieving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. –
- Consult the dealer or an experienced radio/TV technician for help.
Thank you for purchasing a Brydge product. This product comes with a Limited Lifetime Warranty on the terms and conditions set out in this document and at www.brydgekeyboards.com/warranty You must register your product at http://www.brydgekeyboards.com/warranty. within 30 days of purchase, and provide a proof of purchase, in order to be covered by this Limited Lifetime Warranty. If you purchased your product from www.brydgekeyboards.com, the product will automatically be registered. All Brydge warranties are non-transferrable and are only available to the original end-user of the product. Warranties do not apply to products purchased from online vendors unauthorized to sell Brydge branded product, including on eBay.com.
- Further warranty information is available at http://www.brydgekeyboards.com/warranty.
- To obtain warranty service, contact Brydge using the information on http://www.brydgekeyboards.com/warranty, or described at Support@brydgekeyboards.com or +1.435.214.7485. Proof of purchase may be required to verify eligibility.
©2018 Brydge. All Rights Reserved. iPad® and Apple® are registered trademarks of Apple Inc. The Bluetooth word, mark, and logos are owned by Bluetooth SIG, Inc. Use of such marks by Brydge is under license. Brydge is a trademark of Brydge Global Pte. Ltd. Other trademarks and tradenames are those of their respective owners
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>