CAMDEN TXLF-1 (FVIN: 3A) Lazerpoint CM-TXLF Series FOB Style Transmitters Installation Guide
- June 17, 2024
- Camden
Table of Contents
CAMDEN TXLF-1 (FVIN: 3A) Lazerpoint CM-TXLF Series FOB Style Transmitters
Lazerpoint™ CM-TXLF Series
FOB Style Transmitters
INSTALLATION INSTRUCTIONS
GENERAL DESCRIPTION
Camden Lazerpoint™ Radio Controls comprise the following models:
- CM-TXLF-1, CM-TXLF-2, CM-TXLF-4, CM-TXLF-1LP and CM-TXLF-2LP Key Fob Transmitters, as well as;
- CM-TX-9 Wall switch ready transmitter
- CM-TX-99 Plug-in 2-Channel Transmitter
- CM-RX-91 Basic Receiver
- CM-RX-92 Full function (dual relay) Receiver.
These instructions cover the TXLF transmitters.
Camden Key Fob transmitters utilize readily available CR-2032 Lithium
batteries, and special circuitry to assure long life. A proprietary bi-colour
LED circuit is used to annunciate wireless activation, low battery, & Battery
Gas Gauge™ conditions.
SPECIFICATIONS
Models
| TXLF-1 (FVIN: 3A) TXLF-2 (FVIN: 3B) TXLF-4 (FVIN: 3C)
---|---
Buttons / Channels| 1, 2, & 4 respectively
Frequency| Operates in the 902 – 928 MHz ISM Band
Codes| 1 million (20 bit) codes
LED Indicator
| Used for transmit status (green), Low Battery, and Battery Gas Gauge™
indicator (red).
Power| 1 x CR-2032 Lithium battery
Battery Life| Minimum 115,000 operations
Range| Over 250 ft (76 m) open area
Temperature Rating| -40°F to 185°F (-40°C to +85°C)
Dimension| 2 9/16” L x 1 9/16” W x 5/8” D
(102mm x 42mm x 16mm)
INSTALLATION
Mounting
Camden TXLF Fobs can be attached to a key chain using the included ring.
Fobs can also be mounted to a wheelchair by using accessory number # CM-TXLFB
Mounting Base. This unique accessory converts any of the Mini Fobs to a full
size unit which may be clipped to a belt or sun-visor, or fastened to a desk
or counter for reception use. See our Lazerpoint™ spec sheet or TXLFB
Instruction manual for further details.
The CR-2032 battery is pre-installed in the Fob. Simply press the button and
observe the GREEN LED, which indicates proper transmission.
Test the battery strength by pressing and holding the button for approximately
5 seconds. The LED should flash RED 5 times, meaning the battery is at full
capacity. This is the Battery Gas Gauge™ feature. If the LED flashes RED only
1 – 2 times, you should change the battery for a fresh (new) one. See
instructions at right.
When the battery is low and needs to be changed, the LED will indicate a slow
red flash — 1 flash per second. The unit will still continue to function
(transmit) for a time, but the battery should be changed as soon as possible.
Learning the Transmitter(s) to the Receiver
To learn the transmitter into an RX-91 or RX-92 receiver, press the PB1 (or
PB2) button on the Receiver using a small blunt object such as a small blade
screwdriver or similar. Within 10 seconds, press the button on the TXLF
transmitter. The Green LED Array will flash once to confirm enrollment. Repeat
withanyadditionaltransmitters. Pressingthe learned transmitter again will
signal the receiver that you are finished programming and LED’s 1 & 2 will
flash, in an alternating sequence.
Pressing the transmitter a third time will activate the relay and
corresponding LED, and also the device connected to the relay contacts.
For multiple button FOBS – TXLF-2 & TXLF-4, learn the desired button into one
receiver, and the other button(s) into additional receivers. (You could also
learn Button 1 into Channel 1 of the RX-92, and Button 2 into Channel 2 of the
same RX-92.)
Refer to the RX-91 or RX-92 receiver for further programming instructions.
Replacing the Battery
Assembly Instructions
WARRANTY
Camden Door Controls guarantees the CM TXLF series transmitters to be free
from manufacturing defects for 3 years from date of sale. If during the first
3 years a TXLF transmitter fails to perform correctly, it may be returned to
our factory where it will be repaired or replaced (at our discretion) without
charge. Except as stated herein, Camden extends no warranties expressed or
implied regarding function, performance or service.
Batteries are exempt from this warranty.
IC & FCC INFORMATION FOR USERS
IC: 8725A-TXLF
This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
FCC ID: 2AHAB-TXLF
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications made to this equipment not expressly approved by Camden Door Controls could void the user’s authority to operate the equipment.
Opening New Doors to Innovation, Quality and Support!
Call: 1.877.226.3369 / 905.366.3377
Visit: www.camdencontrols.com
File: CM-TXLF Transmitter Manual.indd- Rev.6 Revised: 11/01/2019
Part No: 40-82B160
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>