AMBIENT UMP3 Universal Microphone Power Supply Instruction Manual
- June 6, 2024
- Ambient
Table of Contents
Universal Microphone Power Supply
Instruction Manual
Preparing the UMP III
– Push the battery lever on the bottom in and slide right (direction MIC
connector)
– Insert the battery with the polarity protection gap to the left when looking
at the front
– Close the door and push back to the left
Power on
Plugin the Mic In cable. The device can only be switched on with the Mic In
cable connected.
Press the button until the LED turns from red to green, release. The LED will
now display the current power setting.
Power settings LED color:
- Blue (default): 48V Phantom
- White: 12V Phantom
- Yellow: 12V T-Power
- Red: Low battery, approx. 15min operation left
Note: The default setting is 48V phantom, but the unit will retain a
previously selected mode. To prevent damage caused by improper power mode,
check the currently active setting matches your microphone before connecting
it.
Check the setting while the unit is on briefly tap the button. The Led will
blink in the color of the active setting.
Changing the power setting
Alternate between 48V and 12V Phantom: briefly tap the button twice. The unit
will light up the setting it would switch to. If you want to confirm, tap
while LED is lit, to cancel, wait. The unit will now blink 3 times in the
color of the now active mode.
Enabling T-Power: tap 3 times. The LED will light up yellow. To confirm, tap
the button while LED is lit yellow. The unit will blink 3 times yellow to
indicate T-Power is now activated.
Disabling T-Power: tap the button twice. The Led will light up blue. To
confirm selection tap the button while LED is lit. The unit will blink 3 times
blue to indicate 48V Ph is now activated.
Power off
Press the button until the LED lights up red and briefly blinks, release. Alternatively, simply detach the mic input cable at the unit. You can control by tapping the button.
Connectors
MIC (input):
- Pin 1: GND
- Pin 2: Signal hot (12V on T-Power)
- Pin 3: Signal cold
- Pin 4: Battery negative (must be bridged to pin 1)
TX (output):
- Pin 1: GND
- Pin 2: Signal hot
- Pin 3: Signal cold
Technical Details
- Dimensions (WHD): 44 mm x 66 mm x 20 mm
- Weight (incl. battery): 100 g
- Material: pearl-blasted aluminum, matte black anodized
- Powering: 48 V Phantom | 12 V Phantom | 12 V T-power
- Power supply: 1 NP-50 rechargeable battery
For information on available cables please visit our website.
Schleissheimer Straße 181 C | DE – 80797 Munich | phone +49 89 360 55 10-0 |
www.ambient.de/en |
info@ambient.de
© 2020, Ambient Recording GmbH
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>