cecotec ReadyWarm 21000 Carbon Focus Outdoor Tower Heater User Manual

June 17, 2024
cecotec

cecotec ReadyWarm 21000 Carbon Focus Outdoor Tower Heater

cecotec ReadyWarm 21000 Carbon Focus Outdoor Tower
Heater

SAFETY INFORMATION

Fig 1.

Safety Information

PARTS AND COMPONENTS

  1. Heater head
  2. Upper tube
  3. Central tube X 2
  4. Bottom tube
  5. Cable and plug
  6. Base
  7. Base anchoring
  8. Trim
    Fig 2.
    Parts And Components

BEFORE USE

Installation

General

  • Keep the packaging material out of the reach of children. Check that all parts are present. Before use, make sure that you have removed all wrappings around the head (lamp, socket, and switches). Ensure that the area of use is kept clear and away from flammable materials.
  • Check that the appliance, power cord and plug are not damaged. If you notice any damage, do not connect the device to the mains!
  • Do not connect the outdoor heater to the power supply before it has been fully assembled.
  • To assemble the outdoor heater, you will need to use some specific tools. Follow the instructions below step-by-step. If in doubt, please contact your distributor.

ASSEMBLY

It is recommended that the outdoor heater is mounted between two people.

Fig 3.
Pass the cable through the bottom, through the base and the bottom tube (the plug must remain at the bottom).

Assembly

  • Screw the lower tube securely to the base using the three M6x25 screws.

  • Place the trim piece on the tube.

  • Pass the cable through the central tube (x3) and screw the latter tightly to the lower tube.

  • Then pass the cable through the upper tube and screw it tightly to the central tube.

  • Carefully pull the cable upwards.
    Fig 4.
    Assembly

  • Connect the cable to the plug on the heater head.

  • To fix the connection between the two cables, use the lock/protection box.
    Fig 5.

  1. Re-route the cables, including the protection box, through the upper tube.
  2. Align the heater head with the upper tube and screw them together with the two M8x10 screws.
  3. Hold the heater firmly and hook the cable into the groove at the bottom of the base using the plate and the two self tapping screws.
  4. Anchor the outdoor heater using the three plugs and screws included in the box.
  5. Your standing heater is ready for use.
    Fig 6.
    Assembly

Warning! Do not connect the heater to the mains if you notice any damage (to the heater, the cable, or the plug) and do not connect the heater to the mains before installation is complete.

OPERATION

Start-up and operation

  1. Point the heater head in the correct direction.
  2. Plug the power cord into the outlet (220-240 V / 50 Hz).
  3. The heater is switched on and off by means of the on/off chain (1). The chain can also be used to adjust the power.

Chain positions:

  1. Off
  2. Low power = 900 W
  3. Medium power = 1200 W
  4. Maximum power = 2100 W

Warning:

  • This outdoor heater does not have a thermostat, so it continues to emit heat until it is switched off. Keep an eye on the heater when it is on.
  • Unplug the heater from the wall socket when not in use.

Adjusting the heater head

The height of the heater head can be adjusted by loosening the adjustment screws on both sides of the heater head. When the head is securely in place, be sure to retighten the set screws in the clearance hole.

Warning: the head of the heater must always face downwards.

Fig 8.
Separation hole

Adjusting the heater head
Adjusting the heater head

CLEANING AND MAINTENANCE

Cleaning

  • Before cleaning the appliance, switch it off, unplug it from the mains and allow it to cool down. You can clean the outside of the heater with a clean, soft, lint-free cloth or a soft brush. You can also use a damp (not wet!) cloth with a non-aggressive cleaning agent.
  • Please note that the lamp must be completely dry before it is switched on again. Do not use aggressive cleaning agents, scouring pads, brushes, or chemical cleaning agents, as these may damage the material. In addition, never use flammable cleaning agents such as paraffin or alcohol.
  • Never immerse the plug, power cord or any other part of the appliance in water or any other type of liquid. As it may cause electric shocks.

Maintenance

  • The heater does not include any parts that require maintenance or need to be replaced/ repaired by the user. Therefore, the appliance must not be disassembled by unqualified persons. For safety reasons, the heater must be replaced by a qualified electrician or an approved service company.
  • Damage and malfunctions resulting from repairs or modifications made by the user to the appliance, accidents, misuse, neglect, improper or inadequate maintenance and commercial use invalidate the warranty

TECHNICAL SPECIFICATIONS

  • Product reference: 07817
  • Product: Ready Warm 21000 Carbon Focus
  • Rated voltage: 220-240 V
  • Frequency: 50/60 Hz
  • Power: 2100 W
  • Protection IPX4

DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES

This symbol indicates that, according to the applicable regulations, the product and/or batteries must be disposed of separately from household waste. When this product reaches the end of its shelf life, you should dispose of the cells/batteries/accumulators and take them to a collection point designated by the local authorities.
Consumers must contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries. Compliance with the above guidelines will help protecting the environment.

TECHNICAL SUPPORT AND WARRANTY

Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the time of delivery of the product under the terms, conditions, and deadlines established by the applicable regulations. It is recommended that repairs be carried out by qualified personnel. If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact the official Cecotec Technical Support Service at +34 963 210 728.

The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES, S.L. All rights reserved. The contents of this publication may not, in whole or in part, be reproduced, stored in a retrieval system, transmitted, or distributed by any means (electronic, mechanical, photocopying, recording or similar) without the prior authorization of CECOTEC INNOVACIONES, S.L.

Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

cecotec User Manuals

Related Manuals