MR BEAMS MB980 Wireless Motion Sensor LED Ceiling Light Instruction Manual
- June 17, 2024
- Mr Beams
Table of Contents
MR BEAMS MB980 Wireless Motion Sensor LED Ceiling Light
Thank you for purchasing the Mr Beams® Ceiling Light. We are committed to eliminating darkness using the latest in Light-Emitting Diodes (LEDs). LEDs are the most efficient and durable light sources available. We are certain that your light will contribute to a safer environment and provide light where you need it at a very reasonable cost.
What is included per light
- Wireless LED Ceiling Light
- 2 Screws & 2 Anchors
- Mounting Bracket
What you need to install
- 4 C-Cell Alkaline Batteries
- Screwdriver
Ceiling Light Features
- Motion/Light Sensor: The Ceiling Light instantly turns on when it detects motion from up to 20 feet away. The light sensor conserves battery life by preventing the light from activating in daylight. The light sensor can be disabled – see instructions below.
- Auto Shut-off: The light shuts off automatically after 30 seconds if no motion is detected.
- Bright LED: 100 Lumens covers up to 260 sq ft.
- Durable, Weather Resistant: Tight seals and UV-resistant material allow the Mr. Beams Ceiling Light to work in all weather conditions.
Tips:
- Use only new alkaline C-Cell batteries with 1.5V rating.
- Do not mix old and new batteries. If the batteries are not new, it may cause the light to malfunction.
- Install batteries with polarity in the correct position.
- Light may activate when batteries are inserted. Simply take light into a dark room. Allow batteries to settle, then test activation.
- If your light will not turn off, it means that it is time to replace the batteries.
NOTE: The light sensor only allows light to activate in darkness. We recommend you test in a dark room or closet.
- Remove the mounting bracket from the back of the Ceiling Light. Remove the back plate of the Ceiling Light by removing the thumb screw.
- Insert 4 fresh C batteries.
- To close, align the tab with a notch. Rotate back plate clockwise. Insert thumb screw and tighten.
- Determine the mounting location for the Ceiling Light. If mounting to a wall, position so word “TOP” is at the highest point. The side with the word “TOP” should always face you. Drive two screws (included) through holes of mounting bracket to secure.
- Position the motion sensor lens towards the area of expected motion. Align tabs with grooves and twist the Ceiling Light clockwise until it stops. Make sure light is secure.
Light sensor removal instructions
These instructions are for customers who find there is ambient light in the desired location that prevents their light from activating. Once the sensor is removed, your light will activate, regardless of surrounding lights. Battery life will decrease once the sensor is removed because light will activate more often.
- Remove the mounting bracket from back of the Ceiling Light. Remove the back plate of the light by removing the thumbscrew.
- After removing the battery compartment plate, locate the black rectangular piece in the centre.
- Remove the black rectangular piece with needle nose pliers by lifting up. Once piece is removed, the light sensor will not work until the piece is replaced. Tape the piece to the back of the light to ensure you don’t lose it for future use.
Battery Caution:
- Do not mix old and new batteries
- Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium) or (Nickel Metal Hydride) batteries
- Do not dispose of batteries in fire
- Batteries should be recycled or disposed of as per state and local guidelines
Visit our website to view the installation video 1 year limited warranty. Visit the site for details. 32333 Aurora Rd. Suite 100 Solon, OH 44139
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>