MR BEAMS MB380 Wireless Motion Sensor LED UltraBright Spotlight Instruction Manual
- June 16, 2024
- Mr Beams
Table of Contents
MR BEAMS MB380 Wireless Motion Sensor LED UltraBright Spotlight Instruction
Manual
Installation Instructions
Thank you for purchasing the Mr Beams® Wireless UltraBright Spotlight. We are committed to eliminating darkness using the latest in Light-Emitting Diodes (LEDs). LEDs are the most efficient and durable light sources available. We are certain that your light will contribute to a safer environment and provide light where you need it at a very reasonable cost.
What is included per light:
- 1 Wireless UltraBright Spotlight
- 3 Screws
- 3 Anchors
What you need to install:
- 1 Small Screwdriver
- 4 D-Cell Alkaline Batteries
Spotlight Features:
Motion/Light Sensor: Light instantly turns on when it detects motion from
up to 25 feet away. The light sensor conserves battery life by preventing the
light from activating in daylight.
Auto Shut-off: Light shuts off automatically after 20 seconds if no
motion is detected.
Fully Adjustable: Motion Sensor Spotlight can be rotated 360° as well as
up and down.
Bright LEDs: 300 Lumens covers up to 400 sq ft.
Durable, Weather Resistant: Tight seals and UV resistant material allow
the light to work in all weather conditions.
Tips:
- Use only new alkaline D-Cell batteries with 1.5V rating.
- Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.
- Install batteries with polarity in correct position.
- Light may activate when batteries are inserted. Simply take light into a dark room. Allow batteries to settle, then test activation.
- If your light will not turn off, it means that it is time to replace the batteries
NOTE: Light sensor only allows light to activate in darkness. We recommend you test in a dark room or closet.
-
Remove front cover of Spotlight by rotating counter-clockwise as shown above. Pull face out from cup to reveal battery holder.
-
Separate two parts by squeezing tabs and pulling apart.
-
Insert 4 D-Cell batteries into Spotlight. Attach holder by aligning the grooves on the side and match white arrows, snapping both tabs in the holder.
-
Remove mounting base by turning thumb screw counter-clockwise. Pull mounting base off stem of light.
-
Drive three screws into three holes to mount the mounting base. For best results, drill pilot holes first and insert anchors.
-
Insert spotlight back into mounting base pointed in the desired direction. Tighten mounting base thumb screw.
-
To pivot Spotlight up and down, loosen knuckle screw in the joint of the Spotlight stem and adjust Spotlight head to proper direction. Tighten knuckle screw.
Battery Caution:
- Do not mix old and new batteries
- Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium) or (Nickel Metal Hydride) batteries
- Do not dispose of batteries in fire
- Batteries should be recycled or disposed of as per state and local guidelines
- Visit our website to view installation video. * 1 year limited warranty. Visit site for details. 32333 Aurora Rd. Suite 100 Solon, OH 44139 877.298.9082
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>