Mr Beams MB300 Wireless Motion Sensor LED Mini Spotlight Instruction Manual
- June 16, 2024
- Mr Beams
Table of Contents
Installation Instructions
Wireless Motion Sensor LED Mini Spotlight
MB300/310
MB300 Wireless Motion Sensor LED Mini Spotlight
Thank you for purchasing the Mr. Beams™ Wireless Mini Spotlight. We are committed to eliminating darkness using the latest in Light-Emitting Diodes (LEDs). LEDs are the most efficient and durable light sources available. We are certain that your light will contribute to a safer environment and provide light where you need it at a very reasonable cost.
What is included per light:
- 1 Wireless Spotlight
- 1 Mounting Bracket
- 2 Screws
- 2 Anchors
What you need to install per light:
- 1 Small Screwdriver
- 3 C-Cell Alkaline Batteries
Spotlight Features:
Motion/Light Sensor: Light instantly turns on when it detects motion from up
to 25 feet away. The light sensor conserves battery life by preventing the
light from activating in daylight.
Auto Shut-off: Light shuts off automatically after 30 seconds if no motion is
detected.
Adjustable: Bracket allows light to angle up or down.
Bright LED: 80 lumens covers up to 350 sq ft.
Durable, Weather Resistant: Tight seals and UV resistant material allow the
light to work in all weather conditions.
Tips:
- For best results, use type Alkaline C-Cell batteries with 1.5V rating
- Install only new batteries of the same type in your product
- Failure to insert batteries in the correct polarity, as indicated in the battery compartment, may shorten the life of the batteries or cause batteries to leak
- Do not mix old and new batteries
- Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium) or (Nickel Metal Hydride) batteries
- Do not dispose of batteries in fire
- Batteries should be recycled or disposed of as per state and local guidelines
- Light may activate when batteries are first inserted. Simply take light into dark room Allow batteries to settle, then test activation
NOTE: Light sensor only allows Spotlight to activate in darkness. We recommend you test in a dark room or closet.
Set Up
-
Unscrew thumbscrew on mounting bracket by turning counter-clockwise and set aside.
-
Tilt bracket back slightly.
-
Push bracket down toward light to unlock from keyhole.
-
Gently pull up on post side of bracket and lift off of light.
Install/Change Batteries -
Remove front cover of spotlight by unscrewing counter-clockwise. Pull face from cup to reveal battery holder.
-
Push down on battery door tab to release. Insert 3 C-Cell batteries, with flat side to spring. Attach battery door by inserting tabs into the rectangular holes then push down on front until door clicks into place.
-
Screw face of spotlight back into the cup by turning clockwise 3 full rotations until tightly closed.
Mounting Spotlight -
Determine mounting location and drive two screws directly through two holes in mounting bracket.
-
First, slide the post into bracket, then slide down to locked position.
-
Align opposite end with screw to the hole.
-
Choose preferred angle of light, then tighten thumbscrew to lock in position.
- 1 year limited warranty. See enclosed card for details.
- Visit our website to view installation video.
Surprisingly Bright Light Anywhere
www.mrbeams.com
****32333 Aurora Rd. Suite 100 Solon, OH 44139
877.298.9082