Insight ACT Head Impact Tracker Head Sensor Pro Instruction Manual
- June 17, 2024
- Insight
Table of Contents
INSTRUCTIONS ON USE
ACT Head Impact Tracker head sensor Pro (1.9)
ILLUSTRATRATED INSTRUCTIONS
Battery use
Open the hatch on the back side by lifting it upwards.
Slide in the coin cell battery underneath the silver holder bridge. Make sure the plus-side of the battery is upwards towards you, and away from the circuit board. Make sure the battery is set exactly on top of the silver-colored circle underneath the bridge. Don’t push the battery too far or you might damage the electronics.
Close the hatch by pressing the sides firmly together to seal the locks. Check that sides are seamlessly connected to each other. The sensor turns on when battery is applied, but not all the components necessarily do. Switch the sensor off and back on before use.
Switching the sensor on
Switch the sensor on by pressing the on/off- button once slowly and firmly. Red LED light next to the button starts blinking in slow frequency to signal the sensor is on. If the light blinks in high frequency (in fast pace), the battery is almost empty. Change the battery or ACT Head Impact Tracker might not work as intended. If the light does not come on at all, try with new battery. If the light is still not turning on at all, or the light turns on but it is not blinking, the head sensor is not working and should be replaced.
- Engineering samples will start sending as soon as the sensor is switched on.
- Unregistered normal version will start announcing itself as soon as the sensor is switched on, and will do that for 5 mins. If no connection to application after 5 mins it will automatically turn off.
- Registered normal version (this is how the sensor is used and worn). Create an impact to the sensor for example by lifting it up and dropping it on the table. The sensor is only using radio to communicate the impact events.
Switching the sensor off
Turn sensor off by pressing the on/off-button twice slowly and firmly. Wait to
see one long red LED light signal and then no more blinking to ensure the
sensor is switched off.
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
IC Warning
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>