GLOBAL INDUSTRIAL 670774 Rubber Speed Hump with Mounting Kit Instruction Manual
- June 17, 2024
- GLOBAL INDUSTRIAL
Table of Contents
GLOBAL INDUSTRIAL 670774 Rubber Speed Hump with Mounting Kit
Product Information
Specifications
- Model : 670774
- Product Name : Global Industrial Rubber Speed Hump with Mounting Kit
- Dimensions : 23.5” W x 110” L
- Recommended Vehicle Speed : 5-10 MPH
- Surface Compatibility : Concrete and asphalt surfaces
Product Usage Instructions
What You Need
- High-speed hammer drill with a 3/4 masonry bit
- Mounting screw and expansion screw sleeve (included)
- Nailing hammer
Installation Steps
-
1. Place the speed hump in the designated area and mark the mounting hole placement. - Remove the speed hump and pre-drill holes to install the plastic screw sleeve to the ground.
- Align the rubber endcaps and middle section on top of the plastic screw sleeve.
- Install the mounting screws into the plastic screw sleeves using a hammer.
Warning: Excessive tightening may damage the speed hump.
Package Contents
- Male End Cap (1 piece)
- Middle Section (5 pieces)
- Female End Cap (1 piece)
- Plastic Expansion Screw Sleeve
- Mounting Screw
FAQ
- Q: Can I purchase additional middle sections to lengthen the speed hump?
- A: Yes, the 670779 Global Industrial Rubber Speed Hump, Middle Section is available for additional purchase to lengthen the speed hump.
User’s manual
Customer Service US: 1-800-645-2986
Recommended for concrete and asphalt surfaces
What You Need
High-speed hammer drill with a 3/4″ masonry bit Mounting screw and expansion
screw sleeve (included) Nailing hammer
670779 Global Industrial Rubber Speed Hump, Middle Section is available for additional purchase to lengthen
Package Contents
- Male End Cap (1pcs)
- Middle Section(5pcs)
- Female End Cap(1pcs)
- Plastic Expansion Screw Sleeve
- Mounting Screw
Rubber Speed Hump
Assembly Instructions
- Place the Speed hump in the designated area. Mark mounting hole placement. Remove the speed hump and pre-drill holes to install a plastic screw sleeve to the ground.
- Align rubber endcaps and the middle section on top of the plastic screw sleeve. Install the mounting screws into the plastic screw sleeves using a hammer.
- Warning : Excessive tightening may damage the hump
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>