Holmes HBF2010A 20 Inch Box Fan Metal Owner’s Manual
- June 17, 2024
- Holmes
Table of Contents
Holmes HBF2010A 20 Inch Box Fan Metal
Product Information
Specifications
- Model: HBF2010A/HBF2010C/HBF2001C/HBF2002A
- Power Source: 120V AC electrical outlet
- Intended Use: Household use only
Product Usage Instructions
Important Safety Precautions
- Read all instructions before using this appliance.
- Use fan only for purposes described in the instruction manual.
- To protect against electrical shock, do not immerse unit, plug, or cord in water or spray with liquids. Plug the appliance directly into a 120V AC electrical outlet.
- Close supervision is necessary when any appliance is used by or near children.
- Unplug from the outlet when not in use, when moving the fan from one location to another, before putting on or taking off parts, and before cleaning.
- Avoid contact with moving parts.
- Do not operate in the presence of explosive and/or flammable fumes.
- To avoid fire hazards, NEVER place the cord under rugs or any parts near an open flame, cooking, or other heating appliance.
- Do not operate any appliance with a damaged cord or plug after the appliance malfunctions, or has been dropped/damaged in any manner. Discard the fan or return it to an authorized service facility for examination and/or repair.
- Do not run the cord under the carpeting. Do not cover the cord with throw rugs, runners, or similar coverings. Do not route the cord under furniture or appliances. Arrange the cord away from the traffic area so that it will not be tripped over.
- The use of attachments not recommended or sold by the appliance manufacturer may cause hazards.
- Do not let the cord hang over the edge of a table, or counter, come in contact with hot surfaces or leave exposed to high-traffic areas.
- Do not use outdoors.
- To disconnect, grip the plug and pull from the wall outlet. Never yank on the cord.
- Always use on a dry, level surface.
- Do not operate the fan until fully assembled with all parts properly in place.
- This product is intended for household use ONLY and not for commercial or industrial applications.
- WARNING: To reduce the risk of electrical shock and injury to persons, do not use the window.
- WARNING: To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
- This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the product. If the replacement fuse blows, a short circuit may be present and the product should be discarded or returned to an authorized service facility for examination and/or repair.
Assembly Instructions
- Slide the two feet included in the box into the fan housing until the locking tabs fit securely into the tab locks. Refer to Figure 1.
- Insert the plug end into the back of the fan as shown in Figure
2. Note the orientation of the plug end to the opening in the back of the fan.
Operating Instructions
- Set the fan on a dry, level surface.
FAQ
- Q: Can I use this fan outdoors?
- A: No, this fan is not designed for outdoor use.
- Q: Can I use this fan with a solid-state speed control device?
- A: No, using this fan with any solid-state speed control device may cause a risk of fire or electric shock.
- Q: How should I clean the fan?
- A: Before cleaning, always unplug the fan from the outlet. You can use a soft cloth or brush to gently remove dust from the fan blades and housing. Do not immerse the unit in water or spray it with liquids.
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions should always be taken including the following:
- Read all instructions before using this appliance.
- Use fan only for purposes described in the instruction manual.
- To protect against electrical shock do not immerse unit, plug or cord in water or spray with liquids and plug the appliance directly into a 120V AC electrical outlet.
- Close supervision is necessary when any appliance is used by or near children.
- Unplug from the outlet when not in use, when moving the fan from one location to another, before putting on or taking off parts and before cleaning.
- Avoid contact with moving parts.
- Do not operate in the presence of explosive and/or flammable fumes.
- To avoid fire hazards, NEVER place the cord under rugs or any parts near an open flame, cooking or other heating appliance.
- Do not operate any appliance with a damaged cord or plug after the appliance malfunctions, or has been dropped/damaged in any manner. Discard the fan or return it to an authorized service facility for examination and/or repair.
- Do not run the cord under the carpeting. Do not cover the cord with throw rugs, runners, or similar coverings. Do not route the cord under furniture or appliances. Arrange the cord away from the traffic area so that it will not be tripped over.
- The use of attachments not recommended or sold by the appliance manufacturer may cause hazards.
- Do not let the cord hang over the edge of a table, counter or come in contact with hot surfaces or leave exposed to high-traffic areas.
- Do not use outdoors.
- To disconnect, grip the plug and pull from the wall outlet. Never yank on the cord.
- Always use on a dry, level surface.
- Do not operate the fan until fully assembled with all parts properly in place.
- This product is intended for household use ONLY and not for commercial or industrial applications.
- WARNING: To reduce the risk of electrical shock and injury to persons, do not use the window.
- WARNING: To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
- This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the product. If the replacement fuse blows, a short circuit may be present and the product should be discarded or returned to an authorized service facility for examination and/or repair.
ASSEMBLY INSTRUCTIONS
- Slide the two feet included in the box into the fan housing until the locking tabs fit securely into the tab locks. Refer to Figure 1.
- Insert the plug end into the back of the fan as shown in Figure 2. Note the orientation of the plug end to the opening in the back of the fan.
NOTE: The feet have been designed so that you may wrap the cord around them.
OPERATING INSTRUCTIONS
- Set the fan on a dry, level surface.
- Please make sure the speed control is in the Off (O) position.
- Plug the cord into any standard 120-volt AC outlet.
- The speed is adjustable by turning the speed control located on the back of the Fan to the desired setting.
- 3: HIGH speed setting
- 2: MEDIUM speed setting
- 1: LOW speed setting
- O: OFF
THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician to install the
proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS SAFETY FEATURE IN ANY WAY.
REPLACEABLE FUSE
- If your (2.5 Amp/5 Amp Max, 125 Volt) replaceable fuse blows, please order a new fuse at 1-800-546-5637. Follow the below instructions to replace the fuse on the plug.
User Servicing Instructions
-
Unplug your fan. Grasp the plug and remove it from the receptacle or other outlet device. Do not unplug by pulling on the cord.
-
Open the fuse cover, located on the top of the plug, by using your thumb or a flathead screwdriver to slide the cover down towards the prongs.
NOTE: Ensure that the fuse cover is completely open before attempting to remove the fuse. -
Remove the fuse carefully by using a small screwdriver to pry the fuse out of the compartment by the metal ends of the fuse. (see Figure 3)
-
Place the plug on a solid, flat surface. Insert a new 2.5 Amp (5 Amp Max), 125 Volt fuse into the fuse compartment and use a small screwdriver to secure the metal ends of the fuse into the compartment.
CAUTION: Risk of fire. Replace fuse only with 2.5 Amp (5 Amp Max), 125 Volt fuse. -
The slide fuse cover closed completely. If the fuse cover is difficult to close, make sure the fuse is secured in place completely by pressing down on the metal ends of the fuse.
-
Risk of fire. Do not replace the attachment plug. Contains a safety device (fuse) that should not be removed. Discard the product if the attachment plug is damaged.
FAN CLEANING
- Always unplug the fan before cleaning.
- Do not allow water to drip on or enter into fan housing.
- Be sure to use a soft cloth moistened with a mild soap solution.
- Do not use gasoline, paint thinner or benzene as a cleaner. You may also lightly run a vacuum cleaner nozzle over the front grill to remove any dust or dirt.
Clean the fan grill and housing base with a soft, damp cloth. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water.
FAN BLADE CLEANING
To clean the fan blade remove the front grill by unscrewing the six screws
located around the perimeter.
DO NOT ATTEMPT TO REMOVE THE FAN BLADE. Clean with a soft, damp cloth. Ensure
that the front grill is securely fastened to the fan before beginning
operation.
FAN STORAGE
When storing your fan in the off-season, it is important to keep it in a safe
dry location. It is important to protect the fan head from dust. We strongly
recommend using the original box from purchase.
If you have any questions regarding your product or would like to learn more about other Holmes® products, please contact our Consumer Service Department at 1-800-546-5637 or visit our website at www.holmesproducts.com.
WARRANTY
1-YEAR LIMITED WARRANTY
Sunbeam Products, Inc. doing business as Jarden Consumer Solutions or if, in
Canada, Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer
Solutions (collectively “JCS”) warrants that for one year from the date of
purchase, this product will be free from defects in material and workmanship.
JCS, at its option, will repair or replace this product or any component of
the product found to be defective during the warranty period. Replacement will
be made with a new or remanufactured product or component. If the product is
no longer available, a replacement may be made with a similar product of equal
or greater value. This is your exclusive warranty. Do NOT attempt to repair or
adjust any electrical or mechanical functions on this product. Doing so will
void this warranty. This warranty is valid for the original retail purchaser
from the date of the initial retail purchase and is not transferable. Keep the
original sales receipt. Proof of purchase is required to obtain warranty
performance. JCS dealers, service centres, or retail stores selling JCS
products do not have the right to alter, modify or in any way change the terms
and conditions of this warranty. This warranty does not cover normal wear of
parts or damage resulting from any of the following: negligent use or misuse
of the product, use on improper voltage or current, use contrary to the
operating instructions, disassembly, repair or alteration by anyone other than
JCS or an authorized JCS service centre. Further, the warranty does not cover
Acts of God, such as fire, flood, hurricanes and tornadoes.
What are the limits on JCS’s Liability?
JCS shall not be liable for any incidental or consequential damages caused by
the breach of any express, implied or statutory warranty or condition. Except
to the extent prohibited by applicable law, any implied warranty or condition
of merchantability or fitness for a particular purpose is limited in duration
to the duration of the above warranty. JCS disclaims all other warranties,
conditions or representations, express, implied, statutory or otherwise. JCS
shall not be liable for any damages of any kind resulting from the purchase,
use or misuse of, or inability to use the product including incidental,
special, consequential or similar damages or loss of profits, or for any
breach of contract, fundamental or otherwise, or for any claim brought against
the purchaser by any other party.
Some provinces, states or jurisdictions do not allow the exclusion or
limitation of incidental or consequential damages or limitations on how long
an implied warranty lasts, so the above limitations or exclusion may not apply
to you.
This warranty gives you specific legal rights, and you may also have other
rights that vary from province to province, state to state or jurisdiction to
jurisdiction.
How to Obtain Warranty Service
In the U.S.A.
If you have any questions regarding this warranty or would like to obtain
warranty service, please call
1-800-546-5637 and a convenient service
center address will be provided to you. In the U.S.A., this warranty is
offered by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions
located in Boca Raton, Florida 33431. If you have any other problem or claim
in connection with this product, please write to our Consumer Service
Department. PLEASE DO NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR THE
PLACE OF PURCHASE.
© 2012 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All
Rights Reserved.
Distributed by Sunbeam Products, Inc. doing business as Jarden Consumer
Solutions, Boca Raton, Florida 33431.
CONTACT
FUSIBLE REEMPLAZABLE
- Si el fusible de repuesto (2.5 amperios/ Máximo de 5 amperios, 125 voltios) se daña, ordene uno nuevo al 1-800-546-5637. Siga las siguientes instrucciones para reemplazar el fusible en la clavija.
- Instrucciones de Mantenimiento para el Usuario
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>