Gosafe G1S Asset GPS Tracker User Manual
- June 17, 2024
- GOsafe
Table of Contents
Gosafe G1S Asset GPS Tracker User Manual
ATTENTION
- All wireless data transferring trackers produce interference that may affect other trackers which are placed nearby.
- The tracker may be connected only by qualified individuals.
- The tracker must be firmly fastened in the predefined location.
- Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
INSTRUCTIONS OF SAFETY
- By following these requirements and recommendations you will avoid dangerous situations. You must read these instructions carefully and follow the strictly before operating the tracker!
- Please install the batteries carefully according this user manual indicates to avoid short circuit that may causes malfunction of tracker.
- Before usage, the tracker should be placed so that its LED indicators are visible, which show what status of operation the tracker is in.
- When connecting the connection cables to the vehicle, the appropriate jumpers of the power supply of the vehicle are recommended to be disconnected.
- Before dismounting the tracker from the vehicle, the connection must be disconnected.
LEGAL NOTICE
- Copyright © 2015 Gosafe.
- All rights reserved. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Gosafe is prohibited.
- Other products and company names mentioned herein may be trademarks or trade names of their respective owners.
Specifications
Note: Early production information
Packing list
Features and event
3.1. Features
- IP67 rating which provides protection against temperature/dust/water spray
- Bluetooth connectivity, for wireless configuration and periodical report.
- Endurable battery life for long term deployment, and external battery pack supported
- Built-in 3 axis G-sensor for motion detection
- Light sensor for tracker removing alarm
- GSM jamming detection
- Dynamic report interval according to preset conditions (parking/roaming etc.)
- Fixed distance and fixed angle cornering report
- Flexible report packet size on demand
- Hardware based Geo-fence supported up to 156 for instant notification
- OTA firmware upgrade supported
3.2. Supported event list
Tracker is capable to report below specific events instantly via GPRS/SMS
channel according to setting.
Note: Above events by default are disabled please enable them by configuration tool if necessary or contact your distributor for further information regarding this topic.
Overview
Here gives a brief mechanical structure introduction for G1S
How to
LED behavior
User command
- Command UNO0
This command is to set user phone number#1 that has authority to interact with tracker.
Example:
Phone number: 13800138000, country code: +86
Message sample
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>