xiaomi Electric Scooter 4 Pro Owner’s Manual
- June 4, 2024
- Xiaomi
Table of Contents
Xiaomi Electric Scooter 4 Pro
Specifications
| Product | Name | Xiaomi Electric Scooter 4 Pro |
|---|---|---|
| Model | DDHBC25NEB | |
| Dimensions | Vehicle: L × W × H (cm)[1] | 120 × 48 × 124 |
| After Folding: L × W × H (cm) | 120 × 48 × 51 | |
| Net Weight | Vehicle Net Weight (kg) | 17 |
Rider
| Load Range (kg)| 25–120
Age| 16–50
Body Length (cm)| 120–200
Assembled Electric Scooter
| Max. Speed (km/h)| 25
General Range (km)[2]| Approx. 45
Max. Climbing Angle (%)| Approx. 20
Suitable Surfaces| Cement, asphalt and dirt roads, with benches of less than 1
cm
or crevices narrower than 3 cm.
Operating Temperature in Riding (°C)| -10 to 40
Storage Temperature (°C)| -20 to 45
IP Rating| IPX4
Charging Time (h)| Approx. 8–9
Battery Pack
| Rated Voltage (VDC)| 36
Max. Charge Voltage (VDC)| 42
Rated Energy (Wh)| 446
Intelligent Battery
Management System
| Over-heating, short circuit, over-current, over-discharge, and
over-charge protection
Normal Charging Temperature(°C)| 0 to 40
Rated Capacity (Ah)| 12.4
Wheel Motor| Rated Power (kW; W)| 0.35; 350
Max. Power (kW; W)| 0.7; 700
Battery Charger
| Output Power (kW; W)| 0.07; 70
Input Voltage (VAC)| 100–240
Max. Output Voltage (VDC)| 42
Rated Output (VDC; A)| 41; 1.7
Model[3]| BCTA+71420-1701
Tire| Tires| Material: Natural rubber, synthetic rubber, resin + cord Size:
60/70-7.0
Tire Pressure (psi)| 40–50
Bluetooth| Frequency Band (s)| 2.402–2.480 GHz
Max. RF Power (dBm)| 8
- Vehicle height: From the ground to the top of the scooter.
- General range: Measured when there is no wind and at 25°C, the scooter’s fully charged to ride at a constant speed of 15 km/h on a flat surface with a load of 75 kg.
- To recharge the battery, only use the battery charger provided in the package. See the detailed information of the battery charger in Specifications.
Certifications
Federal Communications Commission (FCC) Compliance Statement for USA
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of
15cm between the radiator & your body.
Industry Canada (IC) Compliance Statement for Canada
This device complies with Industry Canada license-exempt RSS standard (s).
Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>