J-TECH DIGITAL JTECH-WEX-200M4K Series 1X2 Wireless Transmitter HDMI Extender User Manual
- June 16, 2024
- J-TECH DIGITAL
Table of Contents
JTECH-WEX-200M4K Series 1X2 Wireless Transmitter HDMI Extender
Specification
Important safety notice
Please read below safety instructions below carefully before installation and operation:
- Please pay attention to all the warnings and hints on this device.
- Do not expose this unit to rain, moisture, and liquid.
- Do not put any stuff into the device.
- Do not repair the device or open the enclosure without professional person guidance to avoid electronic shock.
- Make sure good ventilation openings to avoid product overheating damage.
- Shut off power and make sure the environment is safe before installation.
- Do not plug in/out the network cables and IR cables when it is in use to avoid cable damage.
- Use DC5V only. Make sure the specification matches if using 3rd party DC adapters.
Introduction
This transmitter extends HDMI signal wirelessly from the source device to display device up to 660ft with the advanced application of HDbitT transport protocol and wireless technology. The signal resolution up to 4Kx2K. It requires no cables between sender (TX) and receiver (RX) which makes the installation easy and clean.
Note
- Transmission distance will be different due to the environment.
- Wall, brick, or glass will shorten the signal cover range or cause big signal loss.
Package contents
Features
- Transmit HDMI signal from source device to display device up to 660ft wirelessly.
- Support IR remote control function to control source device content from a long distance.
- No cable between sender(TX) and receiver(RX)
- Easy and clean installation
Installation Requirement
- HDMI source device (DVD, PS3, Set top box, PC etc)
- HDMI display device ( SDTV, HDTV, and projector etc.).
Panel description
HDMI Extender TX sender
HDMI Extender RX receiver
Connection
- One to One connection
- One to Two Connection
Connection instruction:
- Connect HDMI input with the HDMI source device and connect the IR blaster extension cable with the IR OUT interface of the sender (TX).
- Connect HDMI output with HDMI display device and connect IR receiver extension cable with IR IN interface. 3). Power on the device (power led lights) and it works.
Note:
- When the wireless signal transmits through the wall, glass, or other obstacles, it will cause signal loss. Suggest installing this device in a good environment with few obstacles.
- The external environment wireless signal interferes with the transmission, such as micro waver, wireless mouse and keyboard etc.
Disclaimer
The product name and brand name may be registered trademarks of related
manufacturers. TM and ® may be omitted on the user manual. The pictures on the
user manual are just for reference, and there may be some slight difference
with the real products.
We reserve the right to make changes without further notice to a product or
system described herein to improve reliability, function or design.
FAQ
Q: TV display “waiting for connection” on the bottom right corner?
A: Please check if the power supply of TX (sender) and RX(receiver) is well connected and the power indicator led lights on.
Q: TV display “Please check the TX input signal” ?
A: please check if there is an HDMI signal input of sender TX
Try to connect the signal source directly to display device to see if there is signal output from source device or change the signal source, HDMI cables and try again.
Q: Display not fluent and stable?
A: Please move the position of sender (TX) and receiver (RX) and make sure the
device is within the required signal range.
Press “reset” button on the TX/RX panel, reset and reconnect.
Remove other wireless signal disturbance and reduce the obstacles on the way.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>