LIVEX 48784 Cresthaven 4 Light Instruction Manual
- June 16, 2024
- LIVEX
Table of Contents
LIVEX 48784 Cresthaven 4 Light Instruction Manual
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. 48784 48786 46164 46166
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN
ASSEMBLING THE FIXTURE (Fig.1)
- Shut off the power at the circuit breaker Remove old fixture and all hardware from Junction Box. The junction box is not included.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for
- Determine the desired hanging height. Slide the electrical wires through the tube(F)/shade(E)/tubes(D)/(C)/(B) and canopy(A).
- Raise the tube (F) to top thread of lamp holder(G), by turning it clockwise until tight. Raise the shade(E)/tube(D)/(C)/(B) and canopy(A) to the pipe thread in order, then by turning it clockwise until tight. NOTE: the tube H only for 48786 46166.
- Thread the two mounting screws into the pre-drilled holes in the Mounting plate spaced the same distance apart as the holes in the canopy (A). Attach the Mounting plate to the Junction Box with the two Junction Box screws as shown. The side of the Mounting plate marked “GND” must face to out.
- While holding the fixture lamp towards the ceiling, connect the electrical wires as Shown in 2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise connect fixture’s ground wire directly to the Mounting plate with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box.
- Raise the canopy (A) on to the Junction box, aligning screws on mounting plate with mounting holes in canopy and lock it securely with the column nuts.
- Install the light bulbs(Not included) in accordance with the fixture specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
Your installation is now complete. Return power to the junction box the
fixture.
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at:
800-761-8056
Or visit us on-line at:
WWW.LIVEXLIGHTING.COM
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>